Connect Z-Wave and Zigbee/Thread/BLE antennas to Z-Station and position them vertically. All communications between Z-Way and the server find.z-wave.me are encrypted and protected by Connect the Z-Station to your computer using one of the two USB-cables shipped with the Z-Station. certificates.
Page 3
Interface light sensor and temperature sensor. In this case there will be three separate widgets (7) with individual settings (8). Advanced automation can be configured using local and online Apps. Apps allow you to set up rules Dashboard like “IF > THEN”, to create scheduled scenes, set auto off timers. Using applications you can also add Rooms support for additional devices: IP cameras, Wi-Fi plugs, EnOcean sensors and set up integrations with Widgets...
Z-Station can run Zigbee, Thread, Bluetooth Low Energy or Multi-protocol firmwares. Z-Station can be placed horizontally on a table, on a shelf or vertically on a wall. Use the set of screws for wall-mounting shipped with Z-Station. For smooth installation use the wall-mounting template: Firmware upgrade and switching between different protocols is done using a special tools available from: https://z-wave.me/support/tools-for-zigbee-openthread-ble/...
Antenna Connection To achieve the best radio performance, make sure Z-Station is equipped with two antennas for Z-Wave (868 MHz or 916 MHz) and for Zigbee/Thread/BLE to always position antennas vertically and far from (2.4 GHz). The picture below shows the location of 868/916 MHz and 2.4 GHz antenna connectors.
Page 6
Pins in the ZB row (except for 3V and GND pins) are pins of the Zigbee/Thread/BLE EFR32MG21 chip. Pins in the ZW row (except for 5V and GND pins) are pins of the Z-Wave ZGM130S chip. Z-Station can also run with Z-Uno firmware and drive GPIO pins. Check https://z-uno.z-wave.me for more info about the Z-Uno project.
Box content FCC Statement The Z-Station box includes the following FCC Device ID: 2ALIB-ZMEZSTAZWZB one or more of the following measures: Type: OQPSK items: Antenna Type: External antenna This device complies with Part 15 of the FCC Rules. 1. Reorient or relocate the receiving antenna.
Page 9
Manufactured by Smart Systems Distribution Sàrl 15B, av. Edmond Vaucher 1219 Châtelaine, Switzerland...