Ackuretta CLEANI User Manual

Operating Instructions

Setting the Timer

You must set the timer when you first connect the power adapter. To make
changes to the timer setting:
1. Press the TIME button to change the time value to be either 3, 5, or 10
minutes. Keep pressing the TIME button to cycle through these time settings.

Setting the Mode

You must select the mode when you first connect the power adapter.
The three different modes control whether the cleaning process is performed on
the left tank, right tank, or both tanks.
To change the mode:
1. Press the MODE button to select the tank(s) that you want to use for the
cleaning process.

Starting the Cleaning Process

When you have set the time and selected the mode:
1. Press the START button one time to start the cleaning process.
2. Press the STOP button anytime to stop the cleaning process, or wait until the
bath automatically stops when the set time has elapsed.
Caution
• Do not put the bath in direct sunlight.
• If you use alcohol, make sure you keep it away from sources of ignition.
• Make sure the power switch is turned off before connecting the power cable.
• Do not operate the bath if the tank is empty. There must be fluid in the tank.
• Put the lid on the tank to reduce noise when it is operating.
• Do not move the bath while it is in operation or if there is any fluid in the tank.
• Do not use the bath in an environment where the temperature changes
dramatically.
For community feedback, see our Ackuretta's User Group on Facebook:
http://go.ackuretta.com/fb-group
User Guide
www.ackuretta.com
2022/10