Setting Up The Speakers - Yamaha NS-AP8805 Owner's Manual

Attaching the pedestals to the front speakers
l
(When not wall mounting)
Attach the pedestal to the front speaker as shown right by
using bolts supplied with the product.
Wall mounting the speakers
l
When mounting the speakers on a wall, attach one of the
wall mounting rubber pads provided near each of the
corners on the rear surface of the speaker to prevent the
speaker cable from being caught between the wall and the
speaker.
You can also use the screw holes on the back of the
speaker for installing the speakers on commercially
available speaker brackets.
Front Speakers
3-11/16" (93.5 mm)
Center Speaker
4-5/8"
(117.2 mm)
When using speaker brackets to mount the speakers on a wall or ceiling, it is strongly recommended that
safety wire, which may be included with the bracket, be used between the speaker and the bracket to prevent
the speaker from falling.
Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting
bracket on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the "key hole" opening.
4
NS-AP8805

SETTING UP THE SPEAKERS

Surround Speakers
A screw with a diameter of 1/4" can be used.
(Hole depth: 9/32")
3-11/16" (93.5 mm)
A screw with a diameter
of 1/4" can be used.
(Hole depth: 9/32")
2-3/8" (60 mm)
17" (432 mm)
12-5/16" (312 mm)
2-3/8" 4-7/16"
A screw with a diameter of 1/4" can be used.
(Hole depth: 9/32")
(60 mm) (113.3 mm)
Non-skid pad
Bolt
Pedestal
Bottom of the
front speaker
2
1
Philips driver
Non-skid pads
Spacer for pedestal
Wall / wall support
Min
1"
7/32"
Tapping screw
(Available at the
hardware store)
Wall / wall support
Min
1"
7/32"