VESA LDT50-C024 Instruction Manual

Use with products heavier than the rated weights indicated may result in instability causing possible injury.
Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
Safety gear and proper tools must be used. This product should only be installed by professionals.
Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, contact your place of
purchase for a replacement.
Check that the product is secure and safe to use at regular intervals (at least every three months).
5
6
O
To properly balance the arm with monitors mounted, adjust the spring tension using the
supplied Allen Key as follows:
First, position and firmly hold the arm horizontally
as shown. Ask for assistance should you require it.
To avoid damage to monitors or mount,
always keep the arm in a horizontal
position while making adjustments.
CAUTION
Again, ask for assistance if required.
Unlock
Lock
If the arm rises, turn the adjustment screw
counter-clockwise until it stays in a horizontal
position.
If the arm drops, turn the adjustment screw
clockwise until it stays in a horizontal position.
CAUTION:

·Do not over tighten the screws.
·To prevent damage to the Tension
Indicator, never allow the Red Indicator
Line move beyond the " " and " "
found on the Left and Right Side of the
display window.
Instruction Manual
COUNTERBALANCE
MONITOR ARM
VESA Compatible
LDT50-C024
75x75 100x100
7
8
Note:
If
the
display
does

not
stop
at
your
desired

position,
tighten
the

screws
as
shown.

Note:
If
the
display
does
not
stop
at
your

desired
position,

tighten
the
screw
as

shown.

N
32"
MAX (2~9kg)x2
(4.4~19.8lbs)x2
RATED
FLAT/CURVED