Summary of Contents for C.J. ANDERSON 636-701-SC-N7
- Page 1 IP Camera Network Setup Guide USER MANUAL QUICK START GUIDE Network IP Cameras 636-701-SC-N7 sales@cjanderson.com Phone: 800-252-1910 Int: 708-867-4002 www.cjanderson.com 1 of 10...
-
Page 2: Safety Instruction
IP Camera Network Setup Guide This device meets the CAN ICES-3 (A)/NMB-3(A) standards requirements. Safety Instruction These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss. The precaution measure is divided into ‘Warnings’ and ‘Cautions’: Warnings: Serious injury or death may be caused if any of these warnings are neglected. - Page 3 IP Camera Network Setup Guide Cautions: ⚫ Make sure the power supply voltage is correct before using the camera. ⚫ Do not drop the camera or subject it to physical shock. ⚫ Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of ethanol and wipe it gently.
- Page 4 IP Camera Network Setup Guide The Explosion Proof Network IP cameras are usually installed on a network in either of two ways: Connected to the internal switch of a network video recorder (NVR): In this configuration, Ethernet cables connect the camera directly to an NVR back panel. The NVR automatically "Activates" the camera and configures the camera's network parameters to establish a communications link between them.
- Page 5 IP Camera Network Setup Guide Step 1. Install the SADP Software 1. Download the SADP Tool from the website: https://www.cjanderson.com/hazardous-location-communication-devices/sadp- download At the time this document was published, the file is named: SADPTool.zip and is 115 MB. 2. Un-zip the file on a computer with Microsoft Windows (Windows 7 or newer) that is connected to the LAN where your camera is connected.
- Page 6 IP Camera Network Setup Guide 1. Scan through the list of devices the SADP Tool discovered for the Inactive device you want to activate (see below). Click on the device in the list to highlight it, and then click the select box to check it. 2.
-
Page 7: Step 3. Modify Network Parameters
IP Camera Network Setup Guide Step 3. Modify Network Parameters 1. In the list of devices discovered, find the device you want to change the network settings for, click the select box to check it, and then see the Modify Network Parameters window. See below. 2. - Page 8 IP Camera Network Setup Guide Step 4. Login to the camera Microsoft Internet Explorer is used to access your camera remotely. Internet Explorer must run as an Administrator to use all features available through a remote login to the camera. Setting MS Internet Explorer to run as an Administrator Windows 7: To run Internet Explorer as an Administrator: 1.
- Page 9 IP Camera Network Setup Guide 1. Open your IE browser and enter the IP address of the camera in the URL field. In the example below, the IP address of the camera is 192.168.3.100. 2. In the login window, enter admin for the User Name and password you created in the Password field, then click Login.
- Page 10 IP Camera Network Setup Guide b. In the message bar at the bottom of the screen, click Run. Follow the on-screen instructions to install WebComponents. When the following screen opens, click Finish. The Live View screen with the camera video image should appear. NOTE: Most IP cameras have a Reset button for returning the camera configuration to its factory settings.