OPERATING PROCEDURE
9. Removing the panel
(1) Remove the electrical box fixing cover. (See Photo 1.)
(2) Disconnect the connector for vane motor (CNV: White).
(Refer to 5.)
(3) Loosen the 4 corner panel fixing screws (tapping screw
4×16). (See Figure 4.)
(4) Slide the corner panel to the direction of the arrow 1,
and remove the corner panel. (See Figure 4.)
(5) Remove the 4 installation screws (M5×28). (See Photo
10.)
(6) Release the 2 temporary hanging hooks to remove the
grille. (See Photo 11.)
10. Removing the drain pan
(1) Remove the electrical box. (See photo 3 and refer to 6.)
(2) Remove the bell mouth (tapping screw 4×10 : 2 screws).
(See Photo 5.)
(3) Remove the drain pan (screw M5×10: 4 screws).
OCH625
PHOTOS & ILLUSTRATIONS
Figure 4
Corner panel
Corner panel
Photo 10
Photo 11
Photo 12
Drain pan
fixing screws
41
Screw
①
Close-up
Grille
①
Installation
Temporary hanging hook
Drain pan
Drain pan
fixing screws
screw