Summary of Contents for SISIL SL-980GI
- Page 1 Chest Freezer Instruction manual ■ Please read the instruction manual carefully for proper usage. ■ Please keep the instruction manual well. MODEL NO.: SL-980GI...
-
Page 2: Table Of Contents
Catalogue Part names........................1 Product features.......................2 Mark illustrations......................2 Safety information......................3 Carrying and installing.....................7 Usage at the first time......................8 Thermostat........................8 Replace the door lamp....................8 General knowledge for usage..................9 Cleaning and maintaining the appliance................10 Defrosting........................10 Faults and diagnosing....................11 Non-fault instances......................11... -
Page 3: Part Names
Part names The below picture is for your reference. There maybe some differences from your appliance. 1 - Door 2 - Food basket 3 - Body 4 - Control panel 5 - Wheel 6 - Door lamp OPERATION POWER Product features ■... -
Page 4: Safety Information
Safety information Warning and Attention This appliance is not intended for use by persons(including children) with reduced physical, sensory or mental capabilities , or lack of experience and knowledge, unless they have been given supervision concerning use of the appliance by a person responsible for their safety. If the supply cord is damaged , it must be replaced by a special cord or assembly available from the manufacturer or its service agent. - Page 5 Safety information Warning and Attention When there is some flammable gas (e.g. coal gas, natural gas etc) around the appliance, open the window and let the In the cabinet, do not store flammable, gas out firstly. Do not plug in or close explosive or volatile goods.
- Page 6 Safety information Warning and Attention The working voltage should be 220V +10% /-15 % That is from 187V to 242V. Do not touch the bare pipes or wires to If the working voltage is too low or too high, avoid a potential scald or electrical shock. the compressor will be damaged.
- Page 7 Safety information Warning and Attention Do not touch the surface to avoid any scald Remove the door seal to avoid asphyxia if during working or right after plugging out. children inside the cabinet, when the At this moment, the surface is at a high appliance is abandoned.
-
Page 8: Carrying And Installing
Carrying and installing Check all the positions for the package. Carry the appliance carefully and avoid Pack the appliance according to the orignial collisions and big shakes . one before carrying. Do not place the appliance under sunshine or The incline angle should be less than 45° near heating sources. -
Page 9: Usage At The First Time
Usage at the first time Place the appliance according to the Clean the inner cabinet before using. installing requirements. Open the door for air ventilating. After installing the appliance, wait for 30 minutes at least before switching on the appliance. ( During transportation the oil in the compressor may have flowed into the refrigeration system.) At the beginning, the cabinet is hot and the compressor will work for a long time and then stopped by the thermostat at the set temperature. -
Page 10: General Knowledge For Usage
General knowledge for usage Keep some spaces between stored goods. It do good for cooling air circulating and Seal the food by fresh kept bags or closed heat exchange and a better cooling effect container to avoid smell-mixed or dry. will be achieved. -
Page 11: Cleaning And Maintaining The Appliance
Cleaning and maintaining the appliance Regular cleaning and maintaining can prolong the life of the appliance and increase the cooling efficiency. Plug out before cleaning or maintaining. Clean the inner cabinet and outer shell in soft clothes with neutral agent & warm Clean the door seal by a bleacher which water. -
Page 12: Faults And Diagnosing
Faults and diagnosing No cooling Bad cooling effects - Check if there is a power cut. - Check if the thermostat is on a suitable - Check if the connection between the position. plug and the socket is good. - Check if the appliance is exposed to - Check if the fuse is switched off. - Page 13 ELECTRIC DIAGRAM Thermostat Overloading Protector Compressor Cord&plug Switch2 Switch1 Fan1 Fan2 Green Lamp1 Lamp2 Operate Starter Indicator Power Indicator...
Need help?
Do you have a question about the SL-980GI and is the answer not in the manual?
Questions and answers