Setting The Water Softening System; Special Salt - Bosch SPV6ZMX17E Information For Use

Table of Contents

Advertisement

Water hardness
°E
39 - 62
Note: Set the water hardness determ-
ined on your appliance.
→ "Setting the water softening sys-
tem", Page 25
With a water hardness of 0 - 8 °E
you can dispense with special salt for
dishwashers and switch off the water
softening system.
→ "Switching off the water softening
system", Page 26
10.2 Setting the water soften-
ing system
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 24
Press
⁠ .
2.
To open the basic settings, press
3.
for 3 seconds.
a The display shows H:xx.
a The display shows
Press
repeatedly until the
4.
right water hardness has been set.
The value H:04 is set at the fact-
ory.
To save the settings, press
5.
for 3 seconds.
10.3 Special salt
You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The consumption of
special salt depends on the water
Hardness range
Hard
⁠ .
Water softening system en
mmol/l
5.5 - 8.9
hardness. The higher the water hard-
ness, the greater the consumption of

special salt.

ATTENTION!
Detergent may damage the water
softening system.
Only fill the dispenser of the water
softening system with special dish-
washer salt.
Special salt for dishwashers can
damage the tub due to corrosion.
To make sure that any special salt
that escapes is washed out of the
tub, add the special salt to the dis-
penser for special salt immediately
before the programme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Setting value
H:07
25

Advertisement

Table of Contents
loading

Table of Contents