Panasonic KX-TC1000B Operating Instructions Manual page 12

Things You Should Know
6-E Before Requesting Help
Problem Remedy
The unit does not «Check the settings (1-C).
work. «Charge the battery fully (6-A).
e Clean the charge contacts and charge
again (6-A).
ə Instali the battery properly (6-B).
» Place the handset on the base unit and
; . unplug the AC adaptor to reset. Plug in,
l then try again.
+ Re-insert the handset battery within
3 minutes to avoid memory loss and
place the handset on the base unit.
Then try again.
An alarm tone
sounde when you -
press (TALK).
e You are too far from the base unit.
Move closer and try again.
+ Place the handset on the base unit and try
again,
_ » Plug in the AC adaptor.
s Raise the base unit antenna.
Static, sound cuts . «Locate the handset and the base unit away
invout, fades. from other electrica! appliances (6-C).
interference from «Move closer to the base unit.
other electrical _ «Raise the base unit antenna.
units. «Press to select a clearer channel.
The unit does not . «The ringer volume is set to OFF.
ring. Press (RINGER) while the TALK
indicator light is off (2-B).
While storing a e To answer the call, press (TALK).
phone number, the The program wilt be canceled. Store the
untt atarts to ring. number again.
Section 6
Problem Remedy
e You cannot store a number while the
unit is in the talk mode.
You cannot store a
phone number In
memory. a Do not pause for over 60 seconds while
storing.
You cannot redial b e The redial function does not work right
` pressing (REDIAL). after programming the flash time (5-A)
and storing phone numbers in the
~ speed dialer or one-touch dialer
(3-A, 4-A).
a Access numbers entered after
pressing will not be included
when redialing (5-D).
elf the last number dialed was more than
32 digits long, the number will not be
redialed.
HANDSET LOCATOR) The handset is too far from the base
does not function. unit or is engaged in an outside call.
The RECHARGE e Charge the battery tully (6-A).
indicator flashes or the
unit beeps intermittently.
You charged the battery «Clean the charge contacts and charge
fully, but the RECHARGE
Indicator ftashes.
again (6-A).
s instali a new battery (6-B).
The IN USE/CHARGE
indicator light never
goes out white charging.
e This is normal.
e Call our customer call center at
1-800-211-PANA(7262).
if you cannot solve your
probtem