Advertisement
CONNECTIONS TO YOUR AMPLIFIER
Before making connections, make sure that the amplifier is
switched off.
Loosen
Tighten
Black (–)
Red (+)
Red
Connections
Connect the screw-type input terminals at the rear of the
speakers to the speaker output terminals of your amplifier with
the provided speaker cables.
One side of the speaker cable is red and the other side is black.
Connect the (+) terminals on both the amplifier and the speakers
using this red side. Connect the (–) terminals on both
components using the black side of the cable.
Connect one speaker to the left (marked L) terminals of your
amplifier, and another speaker to the right (marked R) terminals,
making sure not to reverse the polarity (+, –). If one speaker is
connected with reversed polarity, the sound will be unnatural and
lack bass.
Procedure:
Loosen the terminal knob.
Remove approx. 10 mm insulation from the speaker cable and
insert the bare wire end properly into the terminal hole.
Tighten the knob.
Test the security of the connection by tugging lightly on the
cable at the terminal.
Note
Do not let the bare speaker wires touch each other as this
could damage the speaker and/or the amplifier.
Speaker (R)
Speaker (L)
Speakers output
terminals of the
amplifier
Amplifier
REMOVING THE FRONT COVER
The front cover is fastened to the enclosure at four points, and can
be removed if desired. To remove the cover, hold on to both sides
and slowly pull straight away from the speaker. To reattach, line up
the four pegs on the inside surface of the cover with the four
corresponding holes on the speaker and push gently.
Note
When the cover is removed, take care not to touch the speaker
units with your hands or to exert excessive force with tools.
SPECIFICATIONS
Type ........................................... 2-way bass reflex speaker system
Driver .................................................................. 16 cm cone woofer
Impedance ........................................................................... 6 ohms
Frequency Response ............................................... 50 Hz – 30 kHz
Nominal Input Power ................................................................ 60 W
Maximum Input Power ........................................................... 150 W
Sensitivity ................................................................ 90 dB/2.83 V/m
Crossover Frequency .............................................................. 3 kHz
Dimensions (W x H x D) ................................... 233 x 392 x 275 mm
Weight .................................................................................... 6.3 kg
Accessories ................................................ Speaker cable (4 m) x 2
Specifications subject to change without notice due to product
improvements.
Care should be taken not to exceed the input power values
noted above.
3 cm dome tweeter
V585580
Advertisement
