TAKACHI AUGH Series Assembly Instructions

PORTABLE ALUMINIUM
INSTRUMENT CASE with HANDLE
AUGH series
Assembly instructions
Please read this instructions carefully before assembly.
⑩
⑧
③
④
Before Assembly
１．Ensure that the ordered model and the product label on the package matches.
２．Some parts may have unused holes or leftover screws due to the parts standardization.
３．During assembly, ensure screw holes align perfectly. If not, loosen all screws and re-
assemble.
Components
① Corner block x 4
⑥ Corner guard x 8
② Frame x 2
⑧ M3-8 flat head screw x 16
③ Panel support frame x 4
⑩ M5-8 pan head
④ Panel x 2
Recommended torque :
⑤ Cover x 2
M3 -10 hex - 0.2N • m
M5-8 pan head self-tapping screw 1.5N • m
Other screws - 0.3 ~ 0.6N • m
* Recommended torque listed is for reference only;
⑦ Carrying handle x 1
⑨ M3-10 hex screw x 8
⑪ M3-5 original trapezoid
self-tapping screw x 4
head (hex) screw x 8
(Not applicable to some models)
actual may differ. Assemble after testing torque.
Side Panels
A
Align ⑦ carrying handle to the ② frame part with
holes on the body, and secure with ⑩ M5-8 pan
head self-tapping screws.
Connect ① corner blocks onto the ② frames and
secure with ⑧ M3-8 flat head screws.
⑦
①
②
⑨
⑤
⑥
Check that the ribs on ① corner block and the
*
grooves on ② frame are aligned.
Ensure the same for the opposite / bottom side.
Once the two ② frames are assembled as shown in
B
the figure below, proceed to step C .
1/2
2024 TAKACHI ELECTRONICS ENCLOSURE CO., LTD.