Advertisement
Quick Links
Advertisement
Summary of Contents for LAI Slam n Jam
- Page 1 1999 Rev. 26/07/01 INSTRUCTIONS...
- Page 2 LEISURE & ALLIED INDUSTRIES Correspondence regarding this machine should be addressed to your closest LAI Games Distributor, or Leisure and Allied Industries office. For a list of Leisure and Allied office contact details, refer to the back page of this manual.
- Page 3 SLAM ‘N’ JAM ASSEMBLY Quick Guide Do’s and Don’ts for Assembling Slam‘N’Jam read the Slam‘N’Jam assembly manual as it will help you in the correct step by step order of assembly take note of what size bolts are used where when assembling Slam‘N’Jam make sure that all cables are free to move and not pinched or jammed under the playfield or other parts when assembling Slam‘N’Jam.
- Page 4 SLAM ‘N’ JAM ASSEMBLY INSTRUCTIONS ! The photograph below displays the parts and their names for you to refer to while assembling the “Slam ‘n’ Jam”. This will assist you in locating the parts more easily. GAME FRONT & REAR FRONT &...
-
Page 5: Tools Required For Assembly
TOOLS REQUIRED FOR ASSEMBLY ♦ 1 x 4 mm Allen Key ♦ 1 x 150 mm Adjustable Spanner ♦ 1 x 13 mm Ring and Open end Spanner ♦ 1 x 10 mm Ring and Open end Spanner ♦ 1 x 8 mm Ring and Open end Spanner One person is able to do most of the assembly, but using two people will be much easier. - Page 6 STEP TWO: Attaching Rear Side Frames. * NOTE: This job is easiest to complete using two people. One to hold the frame, and one to bolt the frame in place. ! Bolt the two-rear side frames to the front frames using the *eight M8 x 30mm bolts, washers, spring washers and nuts supplied.
- Page 7 STEP FOUR: Ball Gate Cabling. ! Run the Ball Gate Cable from the center of the game cabinet and connect the 6 PIN plug for the Ball Gate Motor . ! Remove the Main Backboard and The Top Spotlight Lighting cables from inside of the Game Cabinet.
- Page 8 STEP SIX: Attaching the Rear Play Field. ! Fit the rear playfield to the rear side frames, and bolt in place using the *six M6 x 40mm Knockdown bolts, washers and Nyloc nuts supplied. * Hardware found in Playfield Pack from Cashbox STEP SEVEN: Attaching Backboard.
- Page 9 STEP EIGHT: Attaching Ball Hoop to Backboard. ! Firmly attach the ball hoop to the backboard using the *four M8 x 45mm bolts and washers supplied. * Hardware found in Ball Hoop Pack from Cashbox STEP NINE: Fitting Ball Sensor. ! Fit the electronic sensor through the hole in the backboard and plug in to the 4 PIN Plug.
- Page 10 STEP TEN: Fitting Sensor Cover. ! Fit the sensor cover onto the four bolts from the ball hoop using the *four sets of M8 washers, spring washers and nuts supplied. * Cover & Hardware found in Ball Hoop Pack from Cashbox STEP ELEVEN: Attaching Top Spotlight Panel.
- Page 11 STEP TWELVE: Fitting the Barrier Panel Assembly. Attach the barrier panel assembly at the top bolt holes using the *two, M8 x 30mm bolts, flat washers, spring washers and nuts supplied. (Figure 1). Next attach at the bottom bolt holes together with the ball stop bar using the *two, M8 x 30mm bolts, flat washers, spring washers and nuts supplied.
- Page 12 STEP THIRTEEN: Rear Cabling & Noise Dampener Bracket. ! Insert the Top Spotlight Panel cable into the conduit on the rear of the backboard and clip the conduit cover firmly in place. ! Attach the adjustable noise dampener bracket to the backboard with the *two, 8mm x 20mm bolts and flat washers provided and adjust so playfield is tight up against the bottom of the Backboard Panel.
- Page 13 STEP FIFTEEN: Attach Frame Braces. REAR BRACE MIDDLE BRACE Attach the Middle and Rear Frame Braces on top of the rubber leveling feet using the four, M12 nuts and spring washers supplied. (Refer to picture below for detail) ASSEMBLY IS NOW COMPLETED. * REFER TO FOLLOWING PAGE FOR PICTURE OF COMPLETED ASSEMBLY NOTE! BE SURE TO CHECK AND TIGHTEN ALL ASSEMBLY BOLTS!
- Page 14 COMPLETE ASSEMBLED MACHINE WARNING! BE SURE TO CHECK MAINS VOLTAGE AND TEST BEFORE USAGE!
- Page 15 + 65-6-261-6674 SINGAPORE 619703 e-mail laigames@leisure.com.sg http://www.laigames.com LAI GAMES DISTRIBUTORS For the latest list of LAI Games Distributors visit our web site at http://www.laigames.com Or contact our International Sales & Service e-mail: laigames@leisure.com.sg ASIA –AUSTRALIA – NEW ZEALAND – EUROPE...