Subscribe to Our Youtube Channel
Summary of Contents for Dyaco CRW900
- Page 1 CRW900 Water Rower Service Manual...
-
Page 2: Table Of Contents
--------------------------------------------Table of Contents------------------------------------------- 1. Troubleshooting 1.1 Speed Sensor Trouble Shooting and Replacement Guide 1.2 Plastic Handle Belt Replacement 1.3 Trouble with console 2. Maintenance... -
Page 3: Troubleshooting
Troubleshooting CRW900... -
Page 4: Speed Sensor Trouble Shooting And Replacement Guide
1.1 Speed Sensor Trouble Shooting and Replacement Guide Speed Sensor Troubleshooting 1. Check the gap between sensor and magnetic ring should be 2-3mm. - Page 5 2. Visually check all 6 magnets in the magnetic ring are present and flush (no need to remove the ring) 3. Check sensor head – the internal sensor should be no more than a few millimeters inside the hole. 4. If the above checks fail to resolve the issue continue to the next section.
- Page 6 Replacement Guide 1. Sensor Removal...
- Page 8 2. Sensor Re-Installation...
-
Page 10: Plastic Handle Belt Replacement
1.2 Plastic Handle Belt Replacement 1. Plastic Handle Belt Removal... - Page 12 2. Plastic Handle Belt Installation...
- Page 13 Video link: https://www.youtube.com/watch?v=R8U6uKkzips...
-
Page 14: Trouble With Console
1.3 Trouble with console Q: The console does not illuminate after battery installation: A: Please confirm that batteries installed incorrectly or need replacing. (◎Check to see if the batteries are installed in the correct position. Reinstall or replace as needed. If the LCD screen fails to illuminate, try rotating the batteries slightly in the computer. - Page 15 for 1 second. 2. The 7-segment display will show “VR”. The time window will show “L”. 3. Adjust VR for the first increment, then press the ENTER KEY to confirm. 4. The time window will show “H”. Adjust VR for the highest increment, then press ENTER button to confirm. 5.
-
Page 16: Maintenance
2. Maintenance... - Page 17 2.1 Lubrication Grease Any kind of lubrication grease, such as super grease would do the job. Open the cap, insert the nozzle into the frame, and spray on the shaft. And that top of the pulley below. Pull the handle strap slowly while putting the grease on.
Need help?
Do you have a question about the CRW900 and is the answer not in the manual?
Questions and answers