Advertisement
Installation Instruction
wall plugs
1. Locate wall studs, install into at least one stud.
Place wall seal/mounting bracket on wall at correct height over centre
of stud and mark hole positions on wall
(minimum 2 supplied screws per bracket).
2. Drill pilot holes into wall stud approximately 60mm deep to
suit mounting screws (and wall plugs if required).
Tip:3mm hole for screws into timber or 8mm hole for wall plugs.
3. Apply small amount of silicon to mounting bracket and wall in
and around the screw holes.
4. Install mounting brackets by screwing onto wall.
Tip: Use appropriate mounting screws for the wall stud material,
supplied screws are for timber wall studs.
5. Slide rail tube into end bracket and push onto wall brackets.
Tip: Rail length can be cut down to a smaller size, simply use an angle
grinder, hacksaw or pipe cutter then deburr the end with a file or
grinder and reinsert into the end bracket.
6. Tighten grub screws with allen key.
Tip: If rail rattles, loosen end bracket, twist slightly and tighten.
Mecca Care 32mm Grab Rail 300/450/600/900/1200mm -Manual
Mecca Care 32mm Grab Rail 300/450/600/900/1200mm -Manual
www.nerotapware.com.au
Advertisement
