Table of Contents
Advertisement
Direct access tuning
Specify the frequency using the numeric buttons to directly tune
to the desired broadcast station.
2]
"BAND
Press BAND to select "FM", "MW" or
ALLOCATION
"LW?
I
The MW frequency step is set to 9 KHz before ship-
ment. To change to 10 kHz step, see below.
The indicator changes each time the button is
pressed.
DIRECT TUNING
Press DIRECT TUNING.
While cursor display is
a
om
WV
MHz
flashing (approx. 10
seconds)
(1 f2[3[\Yelo]
Press the appropriate numeric
but-
If the desired FM frequency is 107.90
tons to enter the frequency.
MHz
lf the frequency has been input correctly, the fre-
quency display will blink.
1] — [0] > [7] — [9] > [9]
QUARTZ
:
;
;
Loci
(reir cary
1. If no button is pressed while the cursor display
col
nw
fit
toed
is flashing, the display wiil return to the frequen-
=
Ss
cy which is currently being received. To re-
liluminates when tuned
specify the frequency,
repeat the procedure
from step 3.
2. If the frequency has not been input correctly,
an error message
will be displayed.
In this
case, re-enter the frequency.
When the FM stereo broadcast is received:
If noise is excessive in the FM stereo mode
This unit will automatically switch to FM stereo reception and the
Press FM MODE. (The FM stereo indicator will switch off.)
FM stereo indicator will illuminate.
The broadcast will be monaural, but noise will be reduced. If the
Sika
button is pressed once more, stereo mode will be resumed.
LOCK
STEREO
in
on
FM
i LI ; a Li re
To change the MW frequency step
Press and hold BAND for about 3 seconds.
IHuminates
(The frequency step changes to 10 kHz per step.)
To return to the previous step, press and hold BAND for about 3
seconds again.
Advertisement
Table of Contents
