Table of Contents
Advertisement
Set the dial mode
1
Select [Menu] >
press [OK] to confirm.
2
Select a dial mode, then press [OK] to
confirm.
» The setting is saved.
Note
•
If your phone is in pulse dial mode, press
call for temporary tone mode. Digits entered for this
call are then sent out as tone signals.
First ring
If you have subscribed to the caller ID service
with your service provider, your phone can
cancel the first ring before the caller ID is
displayed on the screen. After the phone is reset,
it can detect automatically if there is a caller
subscription and start to cancel the first ring. You
can change this setting to suit your preference.
This feature only applies to models with first
ring support.
Turn the first ring on/off
1
Select [Menu] >
press [OK] to confirm.
2
Select [On]/[Off], press [OK] to confirm.
» The setting is saved.
Note
•
To reset the first ring status, go to the reset menu.
> [Dial mode], then
during a
> [First ring], then
Auto clock
Note
•
This service is network dependent.
•
Make sure you have subscribed to the caller ID service
before you use this feature.
It synchronizes the date and time on your phone
with the public switched telephone network
(PSTN) automatically. For the date to be
synchronized, ensure the current year is set.
1
Select [Menu] >
press [OK] to confirm.
2
Select [On]/[Off] . Press [OK].
» The setting is saved. .
Register the handsets
You can register additional handsets to the base
station. The base station can register up to 5
handsets.
Auto registration
Place the unregistered handset on the base
station.
» The handset detects the base station
and registers automatically.
» Registration is completed in less
than two minutes. The base station
automatically assigns a handset number
to the handset.
> [Auto clock], then
EN 29
Advertisement
Table of Contents
