Download
Share
Print this page
  1. Manuals
  2. Brands
  3. N1C Manuals
  4. Transformer
  5. N1C.LR-10TXR
  6. User manual

N1C .LR-10TXR User Manual

Transformer box
Hide thumbs

Advertisement

Quick Links

Download this manual
User Guide
Transformer box
N1C.LR-10TXR

Advertisement

loading
Need help?

Need help?

Do you have a question about the N1C.LR-10TXR and is the answer not in the manual?

Questions and answers

Summary of Contents for N1C N1C.LR-10TXR

  • Page 1 User Guide Transformer box N1C.LR-10TXR...

  • Page 2: Operating Environment

    1. Important Safety Warnings 1.1 Safety instructions Please comply with all warnings and operating instructions in this manual strictly. Save this manual properly and read carefully the following instructions before installing the unit. Do not operate this unit before reading through all safety information and operating instructions carefully.

  • Page 3: Product Overview

    2. Product Overview NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package is damaged. Please keep the original package in a safe place for future use. Rear Panel View Output circuit breaker 240V/30A Output circuit breaker 240V/30A Output circuit breaker 240V/30A Output circuit breaker 240V/30A Output circuit breaker 120V/20A...
  • Page 4 Installation and Setup 3.1 Unpacking & Inspection 1. Remove the Transformer box from the packing. Note: The Transformer box is very heavy, be cautious when unpacking and lifting the unit to avoid injury. 2. Check the inside package Handles for rack installation x 2 ...

  • Page 5: Selecting Installation Position

    Cable glands Screws Metal plates Rails Nuts 3.2 Selecting Installation Position It is necessary to select a proper environment to install the unit, in order to minimize the possibility of damage to the Transformer box and extend the life of the Transformer box. Please follow the instructions below: 1.
  • Page 6 Chart 1 Step 2: Lift the Transformer box module and slide it into rack enclosure. Attach the Transformer box to the rack with screws, nuts and washers (user-provided) through its mounting ears and into the rack rails. Please refer to chart 2. Chart 2 Terminal block wiring diagram of TRANSFORMER BOX...
  • Page 7 Output of the UPS should be connected to the input of transformer box and the output of transformer box is the final output of system. Transformer box Wire Spec (AWG) Torque (N·m) N1C.LR-10TXR Follow below diagram to connect UPS output to Input of transformer box. 240V Input 208V Input...
  • Page 8 Confirm the UPS output voltage through the front panel and verify that it matches the transformer box output voltage. For example, if the input to UPS is 208V, then voltage selection should be 208V. Confirm the UPS output voltage through the front panel and verify that it matches the transformer box output voltage.
  • Page 9 output of L1 or L2 can only be half-loaded. Wiring diagram to connect UPS, transformer box and maintenance bypass Start Up Step 1: Ensure the Mains of the bypass module is connected to the mains, and then switch on the input breaker of the maintenance bypass switch module, the bypass module will supply power to the UPS.

  • Page 10: Appendix A: Input/Output Voltage Selection

    Appendix A: Input/Output Voltage Selection Output Voltage 5-20R Input Voltage (Vac) 208V Input Wire Position 240V Input Wire Position For L14-30R(L1-L2) Output Output Voltage 5-20R Input Voltage (Vac) 208V Input Wire Position 240V Input Wire Position...