S1788P (R, G or Y) High power sounders with 8 high brightness LEDs in either Red, Green or Yellow. The sounder and LEDS can be driven separately if necessary.
There are four programmable tones and flash rates that can be setup on installation using on board jumpers to suit local circumstances.
All are supplied with a back box for surface mounting, can be semi flush mount onto single gang galvanised back box (not supplied)
DWG 60117
The sounder tones are configured by jumpers J1 and J2 as follows:
Jumpers
Sounder
J1at X, J2 at X
High pitch fast warble
J1at X, J2 at Y
High pitch fast pulse
J1at Y, J2 at Y
High pitch slow warble
J1at Y, J2 at X
Low pitch slow pulse
Link B and L to -ve and apply 12vdc to activate both sounder and LEDs
Link B to -ve and apply 12vdc to activate just the sounder
Link L to -ve and apply 12vdc to activate just the LEDs
Do you have a question about the S1788P and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Hoyles S1788P
Page 1
This instruction covers the following products: S1788P (R, G or Y) High power sounders with 8 high brightness LEDs in either Red, Green or Yellow. The sounder and LEDS can be driven separately if necessary. There are four programmable tones and flash rates that can be setup on installation using on board jumpers to suit local circumstances.
Need help?
Do you have a question about the S1788P and is the answer not in the manual?
Questions and answers