Page 2
ASSEMBLY INSTRUCTIONS BALMAIN FEDERATION STYLE FENCE PANEL/GATE FOR FIXING AS A FENCE PANEL 1. Panel Placement: Position your fence panel between the posts, leaving approximately 5mm on either side to accommodate potential panel or post movement. 2. Horizontal Alignment: Once you are satisfied with the height & position of your panel, use saddle clamps to locate position on the underside of th horizontal pipe.
Page 3
ASSEMBLY INSTRUCTIONS FOR FIXING AS A GATE – TOP BRACKET 1. Locate Gate Position: Determine where you want the gate mounted, allowing for a space between 50 and 100mm from the ground to the underside of the gate. 2. Backing Plate Marking: Mark the location of the backing plate, aligning it with the underside of the top horizontal pipe.
Page 4
ASSEMBLY INSTRUCTIONS BALMAIN FEDERATION STYLE GATE FOR FIXING AS A GATE - BOTTOM BRACKET 1. Locate Gate Position: Determine where you want the gate mounted, allowing for a space between 50 and 100mm from the ground to the underside of the gate. When measuring, also allow space between posts to include the hinge and latch set you purchase.
Page 5
ASSEMBLY INSTRUCTIONS FOR FIXING AS A GATE – TOP BRACKET 1. Backing Plate Installation: Once you are satisfied the gate is vertically level, mount the backing plate to the post and pre-drill holes (slightly smaller than the fixings you plan to use - M6 or M8 coach screws). 2.