Summary of Contents for RAPIDFENCE Balmain Federation 100654
- Page 1 Balmain Federation Style Fence Panel Assembly Instructions INSTRUCTION MANUAL Item : 100654 - BALMAIN FEDERATION STYLE FENCE PANEL/GATE 800301 - BALMAIN FEDERATION STYLE GATE...
- Page 2 ASSEMBLY INSTRUCTIONS BALMAIN FEDERATION STYLE FENCE PANEL/GATE FOR FIXING AS A FENCE PANEL 1. Panel Placement: Position your fence panel between the posts, leaving approximately 5mm on either side to accommodate potential panel or post movement. 2. Horizontal Alignment: Once you are satisfied with the height & position of your panel, use saddle clamps to locate position on the underside of th horizontal pipe.
- Page 3 ASSEMBLY INSTRUCTIONS FOR FIXING AS A GATE – TOP BRACKET 1. Locate Gate Position: Determine where you want the gate mounted, allowing for a space between 50 and 100mm from the ground to the underside of the gate. 2. Backing Plate Marking: Mark the location of the backing plate, aligning it with the underside of the top horizontal pipe.
- Page 4 ASSEMBLY INSTRUCTIONS BALMAIN FEDERATION STYLE GATE FOR FIXING AS A GATE - BOTTOM BRACKET 1. Locate Gate Position: Determine where you want the gate mounted, allowing for a space between 50 and 100mm from the ground to the underside of the gate. When measuring, also allow space between posts to include the hinge and latch set you purchase.
- Page 5 ASSEMBLY INSTRUCTIONS FOR FIXING AS A GATE – TOP BRACKET 1. Backing Plate Installation: Once you are satisfied the gate is vertically level, mount the backing plate to the post and pre-drill holes (slightly smaller than the fixings you plan to use - M6 or M8 coach screws). 2.