Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for CHORE WARRIOR 44322
- Page 1 POWER ASSIST WHEELBARROW OWNER'S MANUAL 44322 & 44321 #44322 #44321 Includes frame, Includes frame tires and tub and tires Max load 350 lbs. Customer service: 651.370.7508 Power Assist Technologies Monday – Friday 8am – 5pm CST 926 Dale St N chorewarrior.com...
-
Page 2: Table Of Contents
........Parts inventory Operating your Chore Warrior 14 -15 . -
Page 3: Congratulations On Your Purchase
Never let an adult, child or pet ride in your Chore Warrior due to the risk of possible harm or injury. Avoid operating in the close proximity of adults, children, pets or objects. Keeping a safe distance is the best way to avoid possible harm or injury. -
Page 4: Safety Instructions
• NEVER operate your Chore Warrior at speeds faster than a walk. (3 miles per hour.) The tires are only designed for low speed use. Using your Chore Warrior at higher speeds may result in tire failure or blowouts and could cause injury to others and damage to property. -
Page 5: Battery And Tire Care
Your tires have treads to help it maintain traction and stability. It is essential to inspect the tires before each use. If a tire is cracked, has a bald spot, bulge, cuts, any cords showing, or has uneven tread wear, replace the tire with a Chore Warrior approved tire before further use. Tires with damage or with too little tread will not provide adequate traction which could result in loss of control, possibly leading to serious injury. -
Page 6: Parts Inventory
PARTS INVENTORY Tools Required for Assembly • 27mm or 1 1/16" socket/wrench • 12mm socket/wrench • 16mm or 5/8" socket/wrench • 10mm socket/wrench = LEFT = RIGHT • 13mm or 1/2" deep socket/wrench • 6mm Allen wrench both rachet and extension A. -
Page 7: Drive System Assembly
DRIVE SYSTEM ASSEMBLY IMPORTANT! 1. Attach left and right axles (B) to motor using axle flange gaskets (Q) and axle flange screws (R). TIGHTEN HARDWARE Tighten hardware. After drive system assembly, tighten all hardware. NOTE: red dots (right) and blue dots (left) should line up as shown. You may have to wiggle the axle a bit to "marry"... -
Page 8: Attaching The Tires
ATTACHING TIRES 1. Place axle key-ways (O) into grooves of each axle as shown. 2. Slide tires onto axles, taking care to match up the notch in the wheel with the key-way on the axle. NOTE: Air fill valve on rim of tires should be facing out (opposite side from the motor). -
Page 9: Assembling Main Frame To Drive System
2. Attach right (K) and left (J) legs to the other side of the assembled axle frame mounts. Secure with M8 x 40mm hex bolts (V) and hex nuts (T). NOTE: make sure tabs are facing inwards as shown. Now your Chore Warrior should look like this: chorewarrior.com Customer Service: 651-370-7508... -
Page 10: Attaching Handles And Electronics Box
ATTACHING HANDLES AND ELECTRONICS BOX 1. Insert left handle (G) into assembled frame as shown. Be sure to line 4. Attach the right side of electronics box to right handle as up screw holes. Secure with M8 x 40mm hex bolts (V) and hex nuts ((T). shown using M8 x 40mm hex bolts (V) and hex nuts ((T). -
Page 11: Attaching The Battery Box
ATTACHING BATTERY BOX 1. Position battery box (E) so that the handle is facing away from the motor. Insert (springs side first) into the right side battery mount holes on the frame. 2. Push the battery box to the right to compress springs, then lift left side up and insert into left side mounts as shown. Release. The box should now be suspended between the frame. -
Page 12: Attaching / Adjusting Wiring
ATTACHING / ADJUSTING WIRING 1. Secure wires close to the frame using zip ties (S). Be sure to leave enough slack in the power cord so that it can be easily unplugged from the battery. chorewarrior.com Customer Service: 651-370-7508... -
Page 13: Attaching The Tray Brace / Adding Oil
2. Remove oil plug bolt using a wrench and add all oil provided in squeeze bottle (X). Add slowly until bottle is empty. NOTE: Motor will not be full. The Chore Warrior motors only need 7-8 ounces of oil. Wipe off any excess oil with a rag. Replace bolt; turn clockwise and tighten using a wrench. -
Page 14: Attaching A Tray
ATTACHING A TRAY 1. Lower a 6 Cu. Ft. plastic tray onto the Chore Warrior frame. Line up all bolt holes in the tray with holes of the Chore Warrior frame brackets. 2. Insert M8 x 25mm carriage bolts (U) through all six bolt holes of tray. These will extend through the tray brace (two) and frame (four). Secure all six with M8 hex nuts (T). -
Page 15: Charging The Batteries
A GFCI outlet is recommended. Only charge your batteries in an open, dry, well-ventilated area. ONLY use the charger supplied with your Chore Warrior. Use of other charging systems could damage the unit and may cause harm to you. -
Page 16: Operating Your Chore Warrior
All of the above can cause the Chore Warrior to run out of control, resulting in possible harm and injury to yourself and/ or others. It can also result in damage to your Chore Warrior and/or other property. Keep your feet firmly on the ground and two hands on the Chore Warrior handles to maintain control at all times. -
Page 17: Loose Wiring / 12 Volt Battery Removal
NORMAL STOPPING YOUR CHORE WARRIOR: To stop your Chore Warrior, fully release the thumb throttle and slowly bring the Chore Warrior to a stop. Once at a stop lower the Chore Warrior onto the support legs. NOTE: The Chore Warrior does not have a braking system. -
Page 18: Troubleshooting
• Charge the battery. A new battery should have NOT RUN. been charged for at least 12 hours before using the Chore Warrior for the first time. After first- time use, recharge the battery until the green CHORE WARRIOR WAS charge light illuminates. -
Page 19: Warranty / Product Registration
WARRANTY / PRODUCT REGISTRATION LIMITED WARRANTY AND LIMITATION OF LIABILITY Power Assist Technologies warrants this product, to the original purchaser, for the initial residence in which it is located (upon verification that it is assembled correctly) to be free from defects in materials and or workmanship for a period of 1 YEAR from the date of purchase, with the exception that certain components which wear out upon normal use are excluded from this warranty. -
Page 20: Contact Info
Customer service: 1-651-370-7508 Monday – Friday 8am – 5pm CST www.chorewarrior.com Power Assist Technologies 926 Dale St N St. Paul, MN 55103...
Need help?
Do you have a question about the 44322 and is the answer not in the manual?
Questions and answers