Mosolabs Moso Canopy 5G Indoor SCE5164-B78 Installation Manual And User's Manual

Advertisement

Moso Canopy 5G Indoor
Model: SCE5164-B78
Installation Guide and User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Moso Canopy 5G Indoor SCE5164-B78 and is the answer not in the manual?

Questions and answers

Summary of Contents for Mosolabs Moso Canopy 5G Indoor SCE5164-B78

  • Page 1 Moso Canopy 5G Indoor Model: SCE5164-B78 Installation Guide and User Manual...
  • Page 2: Table Of Contents

    SPECIFICATIONS ............................... 8 ..............................8 ENERAL PECIFICATION RF C ............................... 8 HARACTERISTICS ............................8 EGULATORY EQUIREMENTS CE Statement ................................8 ..............................9 AFETY NFORMATION General Hazard Statement ............................. 9 ............................11 EVICE URFACE LEANING ................................12 CCESSORIES Copyright MosoLabs Inc. 2023...
  • Page 3: Introduction

    2 x Gigabit Ethernet Ports for LAN and WAN, and 1 x Reset Button • Internal N78 antennas • GPS SMA connector to connect GPS antenna • Support PoE++ function on WAN port • One SFP port reserved • 1PPS output port reserved Copyright MosoLabs Inc. 2023...
  • Page 4: Leds

    LEDs SCE5164-B78 has 4 LED indicators. Table below describes the definition of each LED: Copyright MosoLabs Inc. 2023...
  • Page 5: Views

    1 x Reset Button for System Reset or Factory Default ETH1 One Gigabit Ethernet Port ETH2 One Gigabit Ethernet Port, also supporting PoE++ GPS SMA connector One Gigabit SFP Port reserved 1PPS Output 1PPS output port reserved Copyright MosoLabs Inc. 2023...
  • Page 6: Initial Installation

    When power on the device with pre provisioned configuration during production in factory, it will begin the device PnP and provision processes. The PnP and provision process will take approximate 20 min. to bring up and activate the device service. Network Diagram and Device Start up Procedure Copyright MosoLabs Inc. 2023...
  • Page 7: Mechanical Installation

    1. If installing this device as wall mounting, please make sure Ethernet port is downside. 2. If using PoE++ injector for power supply, please make sure the power source of PoE++ injector is from power socket in house. Copyright MosoLabs Inc. 2023...
  • Page 8 3. Wall mounting screw dimension specification is as below, unit is in mm: Copyright MosoLabs Inc. 2023...
  • Page 9: Specifications

    This device complies with Directive 2014/53/EU issued by the Commission of the European Community. Declaration of Conformity: EN55032 EN 303 413 Draft EN 301 908-24 EN 301 489-1 EN 301 489-19 EN 301 489-50 EN 301 908-1 EN 50385 EN 62368-1:2014+A11:2017 EN 62368-1:2014/AC:2015 Copyright MosoLabs Inc. 2023...
  • Page 10: Safety Information

    Contact with energized parts can cause serious injury. At least one other trained person must be in attendance, who can immediately and safely disconnect the system if necessary. This second person must be trained in first aid for emergency purposes Copyright MosoLabs Inc. 2023...
  • Page 11 3-pin grounded outlet must be used. The Cooling vents at the right & left of the enclosure can become obstructed, preventing ventilation of the enclosure. Make sure that the air vent is not obstructed and remains clear at all times. Copyright MosoLabs Inc. 2023...
  • Page 12: Device Surface Cleaning

    Always unplug/disconnect power before apply any cleaning to Device. Warning Do not submerse the Device or its accessories in water or allow water to enter into the case; this may lead to electrical shock and/or damage. Copyright MosoLabs Inc. 2023...
  • Page 13: Accessories

    1.5A, Output: 19 V DC, 3A 1 Piece of 1.5M Power Cord 4590001PWE A Piece of 1.5M/8P8C#26*4P CAT.5E Blue Ethernet 4550159YEJ Cable A Set of Wall Mount or Ceiling Mount Bracket Set 940CXK20VD 1 Set of 10M GPS antenna 617202KPIQ Copyright MosoLabs Inc. 2023...

Table of Contents