Table of Contents
Advertisement
@) SURROUND speaker terminals
@ POWER switch
This is the main power switch of the set. Normally, leave this switch in
the ON position.
@5) AC POWER cord
@6) POWER button
Press to switch the power of the set between ON and stand-by. In the
stand-by mode, the S-BY indicator lights on the FL display. The
power can also be controlled from the remote control unit of the
$R1030 (SR1040).
@ SURROUND MODE button
SURROUND ON/OFF button
@) CENTER MODE button
G0 T.(test) TONE button
6)) DELAY button
62 DIMMER button
Press to switch the brightness of the FL display. Pressing once dims
the display and pressing again returns to the original brightness.
When the set is combined with the SR1030 (SR1040) and DC1010
(DC 1020), this button also controls the FL display panels of these
components (provided that they are connected through the D-BUS).
63) S-INJ. (Sound Injection) button
Press to switch the audio to the audio input from the SR1030
(SR1040) connected to the set.
For example, when this button is pressed to ON while the Input
selector of the AV1030 (AV1040) is set to LD and the receiver is set to
CD, the video source does not change but the audio signal is switched
to the CD signal. This function allows recording by combining desired
audio with the desired video source. The S-INJ indicator in the FL
display lights while the Sound Injection function is ON.
64 COPY button
Press for tape dubbing from VCR1 to VCR2. The contents of tape on
VCR1 can be copied to VCR2 regardless of the SOURCE SELECTOR
setting. In this case, the dubbed video and audio are both those of
VCR1. The V1 = V2 indicator of the FL display lights when this button
is pressed to ON.
65) Display
G6) SOURCE SELECTOR
G2 INPUT LEVEL control
Turn this control to adjust the input level in the Dolby surround mode.
This control is also effective in other modes than the Dolby mode.
Turning the control counterclockwise decreases the input level or
clockwise to increase it.
The control is usually set to the most clockwise position, but it should
be turned counterclockwise in case the sound is distorted even when
the listening volume is decreased.
G8) BALANCE contro!
Turn this control to balance the L and R levels of the front channel.
69) MASTER VOLUME control
DOOR OPEN/CLOSE switch
(touch sensor with the AV1040)
OPERATION OF REMOTE CONTROL UNIT
The AV1040/AV1030 can be remote controlled using an optionally-
available remote control unit. In this case, operate the remote control
operation as described in the following.
CONTROL BUTTONS ON THE REMOTE
CONTROL
ACIOAGSR
AEMOTE CONTROL UNIT
POWER switch
Press this switch to turn the power of the unit ON. Pressing the switch
again turns the power OFF and the unit enters the standky mode.
Function buttons
CD, FM/AM (tuner), DCC, TAPE, TV, LD, VCR 1 and VCR2.
These buttons select the source to be played or recordei,
The indicator blinks for about
10 seconds
when
the
button is
pressed.
Numeric buttons 1 to 9
These buttons are used to enter figures in the selectin
of a tuner
preset station, to set the clock or to set select a CD tack number,
etc. The functions of these buttons are dependent onthe function
button selected.
[4] 0/CL button
This button is used to enter the number
"O" as well is
to cancel
various operations.
Advertisement
Table of Contents
