Advertisement
Should your DVD player develop a problem, please check below before
requesting service:
Symptom
Check and Action
No Power
• Make sure the unit has been powered on manually.
• Check if the power cord has been properly connected tattle power outlet.
Does not play
• No disc, load a disc.
• Disc's region code does not match to that of the player's.
• Disc's rating level is higher than the player's preset rating level.
• Disc is incorrect type for the player.
• Disc is damaged or dirty. Clean the disc or try another one.
. Moisture may have condensed inside the player. Remove the disc
. Check if the TV set has been powered on. Use TV remote to select AN signal for
DVD rather than broadcast.
• Check if the system connection is properly secured.
■ Press the PSCAN button a few times.
noisy / distorted
. The disc is dirty or damaged. Clean the disc or try another disc.
• Reset the color system of the TV set.
• Make sure the DVD is not connected through a VCR.Cable or Satellite dish.
s"°'fU"
see" Set Up Menu." of this manual.
• Select the screen setup from DVD disc menu.
message displayed
Following messages will be displayed when there is a problem with the loaded disc:
• "INVALID REGION:" Disc's region code does not match to that of the olaver's.
. "ENTER PASSWORD:"The Dlaver mav denv a disc with a rating level higher than
the player's preset rating level.
• "WRONG DISC": The player is equipped with automatic disc
quality detection software. When the player detects a problem or
damaged disc, the player may keep playing the disc at lower quality or
stop playing, which will depend on the damage level of the disc.
Malfunction
• Press and hold the standby button (if any) for about 5 seconds to power off.
• Should the player develop a malfunction, unplug the player for
30 minutes. After 30 minutes, power on the player and the restore
Advertisement
