Advertisement
INSTALLATION
SUPPLY
Batteries
Whenever convenient, use AC mains supply if you
want to conserve battery Не.
® Open the battery compartment (fig. 2).
1. Insert
as
indicated
eight
(preferably
Alkaline)
batteries, type R20, UM1 or D-cells (fig. 2).
The battery supply is switched off when the set is
connected to the mains. When changing over to
battery supply,
pull out the plug from
the AC
MAINS socket 43.
2. For the clock and the radio memory,
insert four
batteries, type Вб, ОМЗ or AA-cells (fig. 2).
• Remove the batteries if exhausted or if they will
not be used again for a long period.
Mains
• Check if the mains voltage as shown оп the type
plate corresponds to your local mains supply. If it
does not, consult your dealer or service organisation.
If the set is equipped with a VOLTAGE selector #3,
set this selector to the local mains voltage.
е Connect the mains lead to the AC MAINS socket
43 and the wall socket. The mains supply is now
switched on.
e To disconnect the set from the mains completely,
withdraw the mains plug from the wall socket.
Important note for users in U.K.:
When fitting a mains plug to the mains lead proceed as
follows:
The wires in the mains lead are coloured in accordance
with the following
code:
Blue=Neutral,
Brown=Live.
These
colours
may
not correspond
with the colour
markings
identifying
the terminals
in your
plug, so
proceed as follows:
Connect the Brown wire to the terminal marked L or
coloured Red.
Connect the Blue wire to the terminal marked
N or
coloured Black.
Do not connect either wire to the earth terminal in the
plug, marked E or + or coloured green, or green and
yellow.
Note: This apparatus must be protected by a 3 Amp
Fuse if a 13 Amp plug is used or, if any other type of plug
is used, by a 5 Amp Fuse either in the plug or adapter or
at the distribution board. If in doubt consult a qualified
electrician.
CONNECTIONS
CONNECTIONS - fig. 1-2
Stereo headphone socket (5) N PHONES
For stereo headphones with 3.5 mm
plug. Inserting
the plug will disconnect the loudspeakers.
CD Output sockets CD OUT 42
Cinch-sockets for CD-reproduction (not radio or cas-
sette) through e.g. your stereo system.
e Connect the CD OUT sockets 42 to the input
sockets LINE IN, AUX or CD of the other set.
The CD OUT output signal is not affected by the
position of the controls VOLUME @, BASS/TREBLE
(9) and TURBO BASS GENERATOR 60.
Socket for microphone @ MIC
For a microphone with 3.5 mm plug.
To avoid disturbing noises, reduce the VOLUME (4)
before connecting the microphone.
- 'Public address': you can reproduce your voice
amplified through the loudspeakers: set the mode
selector (6) to TAPE.
- Disc-jockey: you can mix your voice with the CD,
TAPE or TUNER: set the mode selector © to CD,
TAPE or TUNER.
- In position CD or TUNER, you can record it ай on
the cassette deck.
Adjust the sound with the controls VOLUME
@),
BASS/TREBLE (9) and TURBO BASS GENERATOR 40.
На howling sound occurs, keep the microphone away
from the loudspeakers or reduce the VOLUME (2).
Disconnect the microphone when not in use.
Advertisement
