Table of Contents
Advertisement
И
cH
ee
ee
eee
ee
ee
AES
aap
ps:
Important Safegu
FOR YOUR SAFETY, READ AND
RETAIN ALL SAFETY AND OPERATING
INSTRUCTIONS. HEED ALL WARNINGS
IN THE MANUAL AND ON THE UNIT
INSTALLATION
1 POWER SOURCE CAUTION
Operate only from a power source indicated on
the unit or in this manual. If necessary, have your
Electric Utility Service Company or Video Products
Dealer verify the power source in your home.
POLARIZED OR GROUNDING
PLUG
As a Safety feature, this Video product comes with either
a polarized power cord plug (one biade is wider than the
other), or a three-wire grounding type plug.
POLARIZED
PLUG CAUTION:
This plug will only fit into an outlet one ж. If you cannot
fully insert the plug, try reversing it. If it still
hava an electrician install the proper wall outlet.
Do not defeat the safety feature by tampering with the plug.
will not fit,
NDI
AUTION:
This plug will-only fit into a three-hole
grounding outlet.
If necessary, have an electrician install the proper outlet.
Do not defeat the safety feature by tampering with the plug.
3 POWER CORD
Make sure power cords are routed so that
they are not likely to have anything rest on them,
roll over them, or be in the way of walking traffic.
If an extension cord is used, make sure it also
has either a polarized or grounded plug and that
the cords can be securely connected.
Frayed cords, damaged plugs, and damaged or
cracked wire insulation are hazardous and should
be replaced by a qualified service technician.
Overloaded outlets and extension cords are fire
hazards and should be avoided.
DO NOT BLOCK VENTILATION HOLES
Ventilation openings in the cabinet release heat
generated during operation. If they are blocked,
heat build-up inside the unit can cause failures that
may result in a fire hazard or heat damage to cassettes.
For protection, follow these rules:
a. Never cover ventilation slots or the unit
while in use, or operate the unit when placed
on a bed, sofa, rug, or other soft surface.
b. Avoid built-in installation, such as a book case
or rack, unless proper ventilation is provided.
AVOID EXTREMELY
HOT LOCATIONS
OR
SUDDEN TEMPERATURE
CHANGES
Do not piace the unit over or near any kind of heater
or regulator, in direct sunlight, inside a closed vehicle, etc..
Do not move the unit suddenly between areas
of extreme temperature variation. If the unit is suddenly
moved from a cold place to a warm place, moisture
may condense in the unit and on the tape.
TO AVOID PERSONAL INJURY
* Do not place unsecured equipment on a sloping surface.
* Do not place this unit on any support
that is not firm, level, and adequately
strong. The unit could fall causing
serious injury to a child or adult and
damage to the unit.
An appliance and cart combination
should be moved with care.
Quick stops, excessive force, and
uneven surfaces may cause the
appliance and cart combination to overturn.
Carefully follow all operating instructions and use
the manufacturer's recommended accessories
when operating this unit or connecting it to any
other equipment.
Safety Precautions
. Warning:
To prevent fire or shock hazard, do not expose this equipment to rain or moisture.
: CAUTION:
To prevent electric shock, match wide blade of plug to wide siot, fully insert.
Attention:
CAUTION
OF LEGTE
DEA
A
OUTDOOR
ANTENNA INSTALLATION
1 SAFE ANTENNA AND CABLE CONNECTION
If an outside antenna or cable system
is connected to the equipment,
be sure the antenna or cable system
is grounded so as to provide some
protection against built up static
charges and voltage surges.
Section 810 of the National
Electrical Code, ANSI/NFPA 70
in Canada, part 1 of the Canadian
lectrical Code) provides information
with respect to proper grounding of the
mast and supporting structure, grounding
of the lead-in wire to an antenna discharge unit,
size of grounding conductors, location of antenna discharge unit, connection
to grounding electrodes and requirements for the grounding electrode.
KEEP ANTENNA CLEAR OF HIGH VOLTAGE POWER LINES
OR CIRCUITS
An outside antenna system should be located well away from power lines,
electric light or power circuits and where it will never come into contact with
these power sources if it should happen to fall. When installing an outside
MEC -natuma
LECT
N
antenna, extreme care should be taken to avoid touching power lines, circuits
|
or other power sources as this could be fatal. Because of the hazards
involved, antenna installation should be left to a professional.
USING THE VIDEO UNIT
If the unit has been in storage or moved to a new location,
refer first to the INSTALLATION section of these safeguards.
1 KEEP THIS VIDEO UNIT AWAY FROM WATER OR
MOISTURE OF ANY KIND.
2 1F EQUIPMENT iS EXPOSED TO RAIN,
MOISTURE,
OR STRONG IMPACT, unplug the unit and have it inspected
by a qualified service technician before use.
3 DURING AN ELECTRICAL STORM
During a lightning storm, whether indoors or outdoors, or before leaving the
unit unused for extended Pens of time, disconnect all equipment from the
power source as well as the antenna and cable system.
4 WHEN THE UNIT IS PLUGGED
IN
* Never expose the unit to rain or water. DO NOT OPERATE
if liquid has been spilled into the unit. immediately unplug
the unit,
and have it inspected by a service technician. Fire and shock hazards
can result from electrical shorts caused by liquid contact inside.
* Never drop or push any object through openings in the unit. Sorne internal parts
carry hazardous voltages and contact can cause electric shock or fire hazard.
* Avoid placing the unit directly above or below your TV set as this may cause
electrical interference. Keep all magnets away from electronic equipment.
USING ACCESSORIES
Use only accessories recommended by the manufacturer
to avoid risk of fire, shock, or other hazards.
CLEANING THE UNIT
Unplug the unit. Then, use a clean, dry, chamically untreated cloth to gently
remove dust or debris. DO NOT USE cleaning fluids, aerosols, or forced air
that could over-spray, or seep into the unit and cause electrical shock.
л
o
ards and Precautions
|
|
|
|
|
|
|
1
|
1
1
|
1
Any substance such as wax, adhesive tape, etc. may mar the cabinet surface. '
Exposure to greasy, humid, or dusty areas may adversely affect internal parts.
DO NOT SERVICE THIS PRODUCT YOURSELF
If, after carefully following the detailed operating instructions, this Video
product does not operate properly, do not attempt to open or remove covars,
or make any adjustments not described in tha manual.
Unplug the unit and contact a qualified service technician.
IF REPLACEMENT
PARTS ARE REQUIRED
Make sure the service technician uses only parts specified by the manufacturer,
or those having the same safety characteristics as the original parts. The use of
unauthorized substitutes may result in fire, electric shock, or other hazards.
HAVE THE SERVICE TECHNICIAN
PERFORM A SAFETY CHECK
After any service or repairs to the unit, request the service technician to
conduct a thorough safety check as described in the manufacture's service
literature to insure that the video unit is in safe operating condition.
am
N
o
Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne
correspondante de la prise et pousser jusqu'au fond.
AN This symbol warns the user that uninsulated voltage within the unit may have sufficient magnitude to cause
electric shock. Therefore, it is dangerous to make any kind of contact with any inside part of this unit.
This symbol alerts the user that important literature concerning the operation and maintenance of
|
this unit has been included. Therefore, it should be read carefully in order to avoid any problems.
;
PA
| For assistance, call 1-800-211-PANA(7262).
Advertisement
Table of Contents
