Lambda Vector One Quick Start Manual

CONNECTING YOUR WIRED NETWORK

Connect to your wired network by plugging one
end of an Ethernet cable into your router, switch,
or jack designated by your network administrator.
Plug the other end of the Ethernet cable into the
Ethernet port ( B ) on the back of your Vector One.
CONNECTING YOUR KEYBOARD & MOUSE
Connect your keyboard & mouse to any available USB ports
A
( ) on your Vector One, including the USB ports on the top.

CONNECTING YOUR WI-FI ANTENNA

Connect the included antenna to the connectors
( C ) on the rear of your Vector One.

CONNECTING YOUR POWER CABLE

Connect your Vector One's power supply unit (PSU) (
directly to a power outlet using the included cord. Ideally,
the power outlet will be on a dedicated circuit. Make
sure your PSU is switched to the | (on) position.
Note: Do not use a power strip, surge suppressor, or
uninterruptible power supply (UPS or battery backup).
QUESTIONS?
Visit us at
https://lambdalabs.com/support
NEED QUICK ACCESS TO MORE GPUS?
Visit us at
https://lambdalabs.com/service/gpu-cloud
Questions? Visit https://lambdalabs.com/support
©2023 Lambda. Updated December 8, 2023.
E )
Vector One
QUICKSTART GUIDE