Basic Operations; Play; Mute; Stop Playing Eject - Pyle PLDVMP4 Operating Instructions Manual

Basic operation
Basic operation
4. Basic operation
If you have connected the product to TV,
all power lines have been plugged into
receptacles, and loaded the batteries
into remotecontrol, so you can play the
player.
• TurnonTVpower
• If you have connected amplifier, you
should also turn it on, and select proper
amplifier mode according to the type of
discs tobeplayed.
playback, push
[HI]
again to resume
play
Mute
(available to analog audio output
Signal only)
Push [MUTE] to silence the sound of the
player, press it again to return to normal
state.
Play
1. Push [POWER] in the player.
• Control TV remote control to shift TV
to propervideo input mode (VI DEO IN).
2. Push open/close eject player or [
EJECT] buttons on the remotecontrol
tothetray.
• Load a disc in thetray, with label side
upward (see following figure), place
singlediscinthetray,
3. Push
[hi]
PLAY/PAUSE
• The player will close the tray
automatically and beginto read it, Itcan
identify different disc format then
display it on the screen of DVD frontal
panel, afterwards if automatically plays
disc, If directory or menu picture disply
in the screen, you can push the
direction buttons [UP], [DOWN],[LEFT]
and [RIGHT] buttons in the remote
control to move lighting band to desired
track, You can directly push number
buttons to selecttrack.
While playing push
[hi]
to pa use the
Stopplavinq EJECT
1. Push [EJECT]
• unload the disc until the tray is
ejected. After stopping playing, unload
the disc until the tray is ejected.
2. Push [EJECT] to close the tray
3. Press[POWER] to turn off the player.
• Then turn off power of all connected
equipment.
The use of REMOTE SENSOR
If you want to put the DVD player in
where you can not see, please insert
REMOTE SENSOR in the REMOTE
SENSOR INPUT, and put REMOTE
SENSOR on where you can see in
automobile, you can control the DVD
player so long as let REMOTE
CONTROLtoward REMOTE SENSOR.
REMOTE
SENSOR
Att©niion:
(DWhito playing if you find the
picture is not shown in full
screen orsome part hidden or
black and white image
occur.you need to the system,
please selectrightTV system
(PAL or NTSC), Please refer
to instructions of [SYSTEM]
IN CHAPTER 6 or examples
inchapter6.
© When the symbol
shows in TV screen, it
signifies invalid operation or
your operation is not
accepted by theplayer.
l)
o