Conformity Declaration - abc LIGHT HAND XS Instructions For Use Manual

Switch lamp off and connect with USB cable and charger during charging.
The battery indicator will blink during charging.
The battery indicator will stay lighting up after finished the charging.
If the battery indicator did not light up, please remove the charger and try again.
Always only use the charger recommended by ABC Tools to charge the lamp.
The use of a NON-recommended charger can lead to a fire and destroy the lamp.
Before taking the hand lamp into service for the first time charge it for 4-5 hours.
Fully charge the hand lamp before it is stored for a longer period.
• Safety instructions
Do not use the device if there is damage to the housing, plug or cable. Consult your local authorized specialist!
Do not open the device! Repair work and replacing the rechargeable battery pack may only be carried out by electricians.
Carry out cleaning tasks only when the mains plug is removed from the mains power!
There is a risk of short-circuit. Repairs on the device may only be carried out by commissioned and trained persons. Please contact your
nearest authorized branch.
Protect the battery against heat, e. g., against continuous intense sunlight, fire, water, and moisture. Danger of explosion.
If the battery is damaged or not used correctly. Fluids can leak from the battery. Avoid contact with these. Leaking battery fluids can lead
to skin irritation or burns. Rinse off with water if you should come into contact. If the fluid gets into your eyes, make sure you get medical
help.
The lamp is not allowed to be placed on the light surface while being switched on.
Enviromental protection
•
The device should not be discarded in the normal household
waste under any circumstances.
Dispose of the device via an authorized disposal center or your
communal waste disposal facility. Observe the current applicable
Warranty
•
The device has a two years WARRANTY against faulty workmanship or materials.
The guarantee does not apply to damage to the device arising through a failure to comply with the operating instructions.
ABC Tools S.p.A. based in Viale Europa 68/70, 20093 Cologno Monzese (MI)
Declares under his sole responsibility that the product:
to which this declaration refers is in compliance with the Directives: 2014/30/EU
complies with the following Standards: EN 55015:2013+A1:2015 - EN 61547:2009 - EN 55032:2015 - EN 5024:2010+A1:2015
The legal representative:
CONFORMITY DECLARATION 
LED hand lamp N 9164 1005
Date: July 2021