Danby DAC060EB7WDB-RF Owner's Manual page 15

INSTALLATION INSTRUCTIONS
CHECK THE TILT ANGLE
A
The air conditioner should be tilted downward
towards the outside approximately 3° to 4°. This
tilt will encourage any condensed water to drain
to the outside. If any condensed water leaks to the
inside of the house, check the tilt angle and adjust
as necessary.
Measure the tilt angle from the front of the cabinet's
edge. The difference in height between the front and
the back of the appliance, labeled "A" on the image
below, should be approximately 19 mm - 2.5 cm
(3/4" - 1").
L BRACKET
The "L" shaped bracket may come factory installed
on some models.
If the "L" shaped bracket is not pre-installed, attach
it to the top of the cabinet as shown below using the
provided 9.5 mm (3/8") screws (x4).
14