Table of Contents
Advertisement
en Troubleshooting
Fault
The programme does
not start.
The length of the pro-
gramme changes dur-
ing the drying cycle.
Pumping noise.
Buzzing noise.
The drying time is too
long.
Water is leaking from
the appliance.
36
Cause and troubleshooting
Deactivate childproof lock.
▶
→ "Deactivating the childproof lock", Page 29
Start/Reload
Press Start/Reload
▶
Door is not closed.
No programme set.
→ "Setting a programme", Page 25.
1.
→ "Starting the programme", Page 25.
2.
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
Condensation pump active.
Not a fault – normal operating noise.
▶
Compressor ventilation active.
Not a fault – normal operating noise.
▶
Fluff filter is soiled.
→ "Cleaning the fluff filter", Page 26
▶
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is below 30
▶
°C.
The ambient temperature is lower than 15 °C.
Ensure that the ambient temperature is above
▶
15 °C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance
▶
is kept clear.
Heat exchanger is soiled.
Opening the base unit.
1.
→ "Opening the base unit", Page 30.
Cleaning the heat exchanger.
2.
→ "Cleaning the base unit", Page 31.
Closing the base unit.
3.
→ "Closing the base unit", Page 32.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 14
▶
Water drain hose is not connected correctly.
has not been pressed.
.
Advertisement
Table of Contents
