Download Print this page

Advertisement

Quick Links

GB
OPERATING INSTRUCTIONS MANUAL
FLEXBIMEC INTERNATIONAL s.r.l. Vi Roma 26/28 - 42020 Albinea RE Italy
tel.+39 0522 347330 r.a. fax +39 0522 347310
http://www.flexbimec.com
email : flexbimec@flexbimec.com
6446 v 1605 gb

Advertisement

loading

Summary of Contents for Flexbimec 6446

  • Page 1 OPERATING INSTRUCTIONS MANUAL FLEXBIMEC INTERNATIONAL s.r.l. Vi Roma 26/28 - 42020 Albinea RE Italy tel.+39 0522 347330 r.a. fax +39 0522 347310 http://www.flexbimec.com email : flexbimec@flexbimec.com 6446 v 1605 gb...
  • Page 2: Preliminary Inspection

    These pumps are recommended for pumping clean water, water with a moderate impurity load (NGA , PRO-NGA, HF, NF) and chemically non-aggressive fluids . They must be used in compliance with local laws. CAUTION ! Before installation and use read the following instructions carefully. The manufacturer declines all responsibility the event of accident or damage due to negligence or failure to observe the instructions described in this booklet or in conditions that differ from those indicated on the rating plate.
  • Page 3: Conditions Of Use

    CAUTION ! Also check that the data on the rating plate correspond to the required data . If there is any problem contact the supplier immediately, specifying the type of Fault . CAUTION ! if there is any doubt about the safety of the machine, do not use it . CONDITIONS OF USE The following conditions must be observed when using the water pump: Maximum operating pressure: 10 bar (6 bar up to P2= 0.75 kW) (18 bar x PQ3000).
  • Page 4: Electrical Connections

    CAUTION ! the pump can be damaged if it operates with leaks in the suction pipes. A foot valve must always be fitted to the end of the suction tube. The ejector unit should be installed tn wells pump delivery outlet that with diameter no less than 4", 3"...
  • Page 5: Maintenance

    pump motors up to 1.50 kW. Three-phase motors must be protected by the user. Three-phase motors should be installed with a thermal magnetic circuit breaker suitable for use with the current indicated on the pump data plate. If the pump is not fitted with a power cable and plug, foresee the use of a device capable of ensuring the total disconnection of power in the event of category Ill over voltage.
  • Page 6 CAUTION ! The loss of any lubricant contained within the pump will not result in the contamination of the pumped liquid. CAUTION ! The apparatus is not intended for use by people (children included) with Reduced physical, sensorial or mental capabilities, or by those lacking the required experience or knowledge unless supervised or instructed in the use of the apparatus by a person responsible for their safety.