Eastern Times Technology FC2922 User Manual

Table of Contents

Download this manual

FC2922 User Manual

Please note that only certified personnel is allowed to perform the installation referenced in

this manual.

FCC Compliance Statements

The Federal Communications Commission requires compliance statements for the following:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm

between the radiator & your body.

Radio Module

Connect option 1: Base socket with band cable

Table of Contents

Do you have a question about the FC2922 and is the answer not in the manual?

Page 1 FC2922 User Manual Please note that only certified personnel is allowed to perform the installation referenced in this manual. FCC Compliance Statements The Federal Communications Commission requires compliance statements for the following: FCC Part 15.19 Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 2 Connect option 2: Base socket w/o band cable Install / Setup 1. Connect the antenna cable to the radio module 2. Connect the radio module to the base socket / band cable 3. Insert the batteries into the battery case 4.
Page 3 Compliance statement (part 15.19) This device complies with part 15 of the FCC Rules and to RSS of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.