Related Manuals for Vitrifrigo Vfree PLUS VFT30
Summary of Contents for Vitrifrigo Vfree PLUS VFT30
- Page 1 INSTRUCTION MANUAL PORTABLE FRIDGES AND FREEZERS VFT30 by VITRIFRIGO THANK YOU FOR PURCHASING A VITRIFRIGO PRODUCT...
-
Page 2: Table Of Contents
Index 1. SAFETY INSTRUCTIONS 2. PRODUCT FEATURES 3. PRODUCT STRUCTURE 4. INSTALLATION 5. FUNCTIONALITY AND OPERATION 6. BATTERY OPERATION 7. CARE AND MAINTENANCE 8. TROUBLESHOOTING 9. WARRANTY 10. TECHNICAL INFORMATION 11. SMART APP CONTROL 12. INFORMATION NOTE ON THE APP (13.01.2023) UE DECLARATION OF CONFORMITY PRODUCT IDENTIFICATION... -
Page 3: Safety Instructions
1. SAFETY INSTRUCTIONS WARNING: fire risk. The device contains refrigerant gas. If in the fridge there is flammable gas, you will find this label on the compressor. In this case, some special precautions must be taken: • Do not operate the appliance if it is visibly damaged. •... - Page 4 CAUTION! • Repairs may only be carried out by qualified personnel. Incorrect repair may cause danger. The lamp and supply cord must be replaced by the manufacturer or qualified persons. • Do not try to disassemble or modify the unit. •...
-
Page 5: Product Features
- Camping, Farm houses and by clients in hotels, motels and other residential environments; - Bed and breakfast type environments; - Catering and similar non-retail applications. • The appliance should be placed at dry place and prevent it from water splashing, rain and moisture. -
Page 6: Installation
4. INSTALLATION • Telescoping handle installation: use a Phillips screwdriver to tighten the 4 screws. • Wheel installation: use a rubber hammer to knock the wheel axle into the slot (if you use a iron hammer, a layer of cloth should be placed on the box and axle to prevent damage). -
Page 7: Battery Operation
Cooling Mode: under the running state, press to switch MAX (fast cooling) and ECO (Energy saving Mode).(*Factory setting is MAX.) Battery Protection Mode: under the running state, long press for three seconds until screen flashes, then press again to select protection mode H(High), M(Medium) and L(Low) (*Factory setting is H.) Voltage Reference: INPUT... -
Page 8: Care And Maintenance
Warning: do not disassemble the battery! • Battery charging (for reference only): MODE 1 Charge in the fridge in standby mode A - Wall outlet AC 100~240V (using dedicated adapter, charging MODE 1 time≈8h) B - Car cigarette lighter DC 12/24V (when the input voltage>13.5V, charging time≈8h) C - Solar 12~50V... -
Page 9: Troubleshooting
• Remove the cover and drain from the hole at the bottom of the device. • Use wet cloth to clean the device and dry it. • Do not soak the fridge in water and do not wash it directly. •... -
Page 10: Warranty
• Possible cause: low voltage to fridge. Code F1 displayed Adjust the battery protection from High to Medium or from Medium to Low. • Possible cause: condenser fan is overloaded. Disconnect power to fridge for Code F2 displayed 5 minutes & re-start. If the code shows again, contact manufacturer for service. •...
Need help?
Do you have a question about the Vfree PLUS VFT30 and is the answer not in the manual?
Questions and answers