Summary of Contents for Barbarian Basketball Systems TP-5X60
Page 1
Barbarian Basketball Systems Inc. Titanium Series ADJUSTABLE BASKETBALL SYSTEM ASSEMBLY INSTRUCTIONS AND OWNER'S MANUAL Model - TP-5X60 WARNING FAILURE TO COMPLY WITH ANY OF THE WARNINGS IN THESE INSTRUCTIONS MAY RESULT IN SERIOUS PERSONAL INJURY. FAILURE TO COMPLY MAY ALSO RESULT IN PROPERTY DAMAGE.
Page 2
TOOLS AND MATERIALS REQUIRED FOR ASSEMBLY (Not Included) 1. 2 Adjustable Wrenches 10. Concrete-1/2 yard or 14-16 2. Socket Set Bags, (80 lb. bags) 3. 9/16" Wrench 11. Phillips Head Screwdriver 4. 3/4" Wrench 12. A minimum of 2 Ladders 5.
Page 3
Verify all parts listed on packing list are present prior to installation. Contact our Customer Service at 620-662-2233 for assistance with replacement of any parts missing or damaged. Backboard H frame Rim pad PARTS LIST ITEM QTY DESCRIPTION 5"x5"Main Post Actuator Spring-Assist Cartridge Pole &...
Page 4
NOTE: Before digging, call to locate any buried utility lines. ’ NOTE: At rim height 10 , distance from the face of backboard to the front of Main Post(A) is 36 , Choose the proper location to dig ” for the concrete footing: a.
Page 5
STEP C a. Mix the concrete according to the instructions on the bags. Note that a thicker mix of concrete will dry stronger than a thin mix. Pour the concrete into the hole, stopping approximately 18 inches from the top of the hole.
Page 6
WARNING *BECAUSE OF THE SIZE AND WEIGHT OF THE SYSTEM, A MINIMUM OF THREE ADULTS ARE REQUIRED FOR THE FOLLOWING STEPS* STEP1 A. Slide a 18mm Thick Washer (U3) over each of the J-Bolts(U2) as shown in FIGURE 1A. B. Remove the Padding from Main Post (A). Place the Main Post (A) over the J-Bolts. Slide a 18mm Thick Washer(U3), a Lock washer M18 (U6) and thread a 18mm Hex Nut (U4) to each J-bolt.
Page 7
STEP 3 Connect Actuator to Main Extension arm. Place the upper bracket of Actuator(B) between the last set of welded tubes on the Main Extension Note: Arm (F), attach the two parts using Hex bolt M16X320mm Nylon washer may (#5), two Flat Washers M18 (#9), one Lock nut (#11). be pre-installed Connect Actuator(B) to the mounting bracket welded in the middle of Post (A), using one Hex Bolt...
Page 8
STEP 6 H frame Attach the Backboard to Main Extension Arm(F) by using one Hex Bolt M16x320 (#5), two Flat Washers M16 (#9), two Nylon washers M16 (#2), one Lock nut M16 (#11). Note: Nylon washers go between Main extension Arm Bracket (F) and Backboard H frame.