Subscribe to Our Youtube Channel
Related Manuals for Steibel Eltron DCE-C 6/8 Trend
Summary of Contents for Steibel Eltron DCE-C 6/8 Trend
- Page 1 Field test trial 1 20.03.2018 OPERATION AND INSTALLATION Electronically controlled compact instantaneous water heater » DCE-C 6/8 Trend » DCE-C 10/12 Trend...
-
Page 2: Table Of Contents
CONTENTS | SpECial iNfOrmaTiON SpECial iNfOrmaTiON SPECIAL INFORMATION OPERATION General information �����������������������������������������3 Safety instructions ����������������������������������������������� 3 - The appliance may be used by children aged 3 Other symbols in this documentation ����������������������� 4 and older and persons with reduced physical, Units of measurement ������������������������������������������ 4 sensory or mental capabilities or a lack of ex- Safety ����������������������������������������������������������4 perience and know-how, provided that they... -
Page 3: General Information
OpEraTiON General information OpEraTiON - Drain the appliance as described in chapter "Installation / Maintenance / Draining the appliance". General information The chapters "Special information" and "Operation" are intended for both users and qualified contractors. The chapter "Installation" is intended for qualified contractors. Note Read these instructions carefully before using the appli- ance and retain them for future reference. -
Page 4: Other Symbols In This Documentation
OpEraTiON Safety Other symbols in this documentation WARNING Injury The appliance may be used by children aged 3 and older Note and persons with reduced physical, sensory or mental General information is identified by the adjacent symbol. capabilities or a lack of experience and know-how, pro- f Read these texts carefully. -
Page 5: Recommended Settings
OpEraTiON Cleaning, care and maintenance Recommended settings Recommended setting for operation with a thermostatic valve and water preheated by solar energy Your instantaneous water heater offers maximum precision and f Set the temperature at the appliance to the maximum maximum convenience in DHW provision. Should you nonetheless temperature. -
Page 6: Installation
iNSTallaTiON Safety iNSTallaTiON Accessories Taps/valves - MEKD mono lever kitchen pressure tap Safety - MEBD mono lever bath pressure tap Only a qualified contractor should carry out installation, commis- Installation kit for water installation on unfinished walls sioning, maintenance and repair of the appliance. [Not available in "Field test trial 1".] General safety instructions The following accessories are required for water installation on... -
Page 7: Minimum Clearances
iNSTallaTiON installation Installation Note f Mount the appliance on the wall. The wall must have sufficient load bearing capacity. factory settings DCE-C 6/8 DCE-C 10/12 Trend Trend Internal anti-scalding protection in °C Minimum clearances Connected load in kW Standard installation DCE-C 6/8 DCE-C 10/12 Trend Trend Electrical connection from below, installa-... -
Page 8: Commissioning
iNSTallaTiON Commissioning Preparation Making the electrical connection WARNING Electrocution Carry out all electrical connection and installation work in accordance with relevant regulations. WARNING Electrocution The connection to the power supply is only permissible as a permanent connection in conjunction with the re- movable cable grommet. -
Page 9: Initial Start-Up
iNSTallaTiON appliance shutdown Internal anti-scalding protection via jumper slot [Not available for "Field test trial 1".] Jumper position Description For example, nurseries, hospitals etc. Max. for shower operation Factory setting f Activate the safety switch by firmly pressing the reset button No jumper Limited to 43 °C (the appliance is delivered with the safety switch disabled). -
Page 10: Alternative Installation Methods
iNSTallaTiON alternative installation methods 12. Alternative installation methods Note This type of connection changes the IP rating of the ap- [Only IP 24 achieved in "Field test trial 1".] pliance. f Change the type plate. Cross out "IP 25" and mark Electrical connection ip rating the box "IP 24". -
Page 11: Water Installation On Unfinished Walls
iNSTallaTiON alternative installation methods 12.4 Water installation on unfinished walls [Not available in "Field test trial 1".] You will need the appropriate accessories to carry out installa- tion. The installation kit for water installation on unfinished walls contains: - 2 cable grommets to seal the apertures in the appliance back panel. -
Page 12: Operation With Preheated Water
iNSTallaTiON Service information 13. Service information f Fit the cable grommets in the appliance back panel from the front. f Secure the appliance with suitable fixing materials (screws Connection overview / Component overview and raw plugs are not part of the standard delivery). f Secure the DHW connection pipe with a flat gasket and the cold water inlet line with the strainer (from the accessories) to the twin connectors. -
Page 13: Maintenance
Entry electrical cables II Installation on unfinished walls 16. Specification 16.2 Wiring diagram 16.1 Dimensions and connections DCE-C 6/8 Trend 2/GRD ~ 208 - 240 V 1/N/PE ~ 208 - 240 V DCE-C 10/12 Trend 2/GRD ~ 208 - 240 V 1/N/PE ~ 208 - 240 V... -
Page 14: Domestic Hot Water Output
iNSTallaTiON Specification 16.3 Domestic hot water output 16.4 Application areas / Conversion table The DHW output is subject to the connected power supply, the Specific electrical resistance and specific electrical conductivity. appliance's connected load and the cold water inlet temperature. Standard specifica- The rated voltage and rated output can be found on the type plate. -
Page 15: Data Table
INSTALLATION | GUARANTEE | ENVIRONMENT AND RECYCLING Specification 16.9 Data table [Only IP 24 achieved in "Field test trial 1".] DCE-C 6/8 Trend DCE-C 10/12 Trend 238148 238149 Electrical data Rated voltage Rated output 5.0/6.6 5.4/7.2 6.0/8.0 6.6/8.7 7.2/9.6 8.3/9.9 9.0/10.7 10.0/12.0 11.0/13.1 12.0/14.3 Rated current A 25.0/33.0 26.0/34.6 27.3/36.4 28.7/37.8 30.0/40.0 41.5/49.5 43.3/51.4 45.5/54.5 47.8/57.0 50.0/59.6... - Page 16 Deutschland Verkauf Tel. 05531 702-110 | Fax 05531 702-95108 | info-center@stiebel-eltron.de STIEBEL ELTRON GmbH & Co. KG Kundendienst Tel. 05531 702-111 | Fax 05531 702-95890 | kundendienst@stiebel-eltron.de Dr.-Stiebel-Straße 33 | 37603 Holzminden Ersatzteilverkauf Tel. 05531 702-120 | Fax 05531 702-95335 | ersatzteile@stiebel-eltron.de Tel.
Need help?
Do you have a question about the DCE-C 6/8 Trend and is the answer not in the manual?
Questions and answers