Summary of Contents for Patriot PA0118
- Page 1 Oil Fliter Operation Manual Model No.: PA0118 Please read and keep these instructions for future reference. For indoor use only.
-
Page 2: Important Safety Information
IMPORTANT SAFETY INFORMATION As is the case with most commercial equipment, your oil filter should be used with caution. Please read the following warnings to avoid potential injuries. 1 .This equipment utilizes high voltage, it should only be installed and serviced by a licensed electrician or trained servicer. Attempting to install or service the equipment yourself could result in serious, potentially fatal injuries. - Page 3 12. DO NOT attempt to move this appliance or transfer hot liquids from one container to another when the unit is at operating temperature or filled with hot liquids. 13. DO NOT leave appliance unattended while draining or refilling with oil/shortening.
-
Page 4: Identification Of Key Parts
IDENTIFICATION OF KEY PARTS ① Handle ②Hose ③Filter Tank ④ Filter Leaf Assembly ⑤Caster ⑥Standpipe Assembly ⑦Power supply socket ⑧Power switch ⑩Suction Assembly ⑪Discharge Assembly ⑨ Pump motor... -
Page 5: Specification
Package Size Model No. Product Size 17.13"L x 36"W x 33.5"H 30"L x 19"W x 14.8"H PA0118 115V/250W INSTALLATION After removing the outer shipping carton and packaging, place the machine on the floor or other flat surface. 1. Hang the motor assembly on the filter tank. -
Page 6: Operation
OPERATION 1. Shut off fryer. Be sure frying oil is at frying temperature before filtering. 2. Be sure the power switch is in the “OFF” position. 3. Plug the male end of the power cord into the socket and socket into a 110 volt receptacle. - Page 7 CAUTION: DO NOT MOVE FILTER MACHINE DURING USE. DO NOT TOUCH FILTER TANK. IT CONTAINS HOT FRYING OIL. 7. Position the discharge nozzle over the fryer. Turn the power switch to the “ON” position. With the drain open,rinse the crumbs and sediment form the fryer with hot oil.
- Page 8 6. Wash filter plate and thoroughly rinse with hot water; dry well. 7. Remove and wash tank. Rinse and dry thoroughly. 8. Replace tank onto filter. 9. Wash clamp assembly, rinse with hot water, and dry well. 10. Screw wing nuts back on clamp assembly and install in tank. Disassemble Filter Leaf Assembly &...
- Page 9 To Clean the Filter Leaf Assembly A. Clean the two seal frame pieces (1), screens (2), and insert (3) with hot water from a spray nozzle. If necessary, the groove in the seal frame pieces (1) can be cleaned with the edge of a SCOTCH-BRITE type pad. B.