Advertisement

NINJA
Instruction Manual
Operators and maintenance personnel must read and understand this manual
before attempting to operate the unit. This manual has important information for
use and safe operation. Keep this manual on file and readily available.
Ashbys Cleaning Equipment
support@ashbys-uk.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NINJA and is the answer not in the manual?

Questions and answers

Summary of Contents for Ashbys NINJA

  • Page 1 Instruction Manual Operators and maintenance personnel must read and understand this manual before attempting to operate the unit. This manual has important information for use and safe operation. Keep this manual on file and readily available. Ashbys Cleaning Equipment support@ashbys-uk.com...
  • Page 2: Table Of Contents

    Emptying after Hot Solvent Extraction Cleaning ..................7 Good Practices ..............................8 Exploded Diagram ............................9 Wiring diagram for Standard Ninja with Built in Immersion Heater ............10 Warranty Terms & Conditions ........................11 Conditions of Warranty ..........................11 Page 2 of 11...
  • Page 3: Important - Please Note

    For carpet cleaning – Ashbys Premium Extraction Liquid 5 Ltr PC7735 (pH 10.7).  For upholstery and rug cleaning - Ashbys Liquid Extraction Cleaner 5 Ltr PC7736 (pH 9). These products are suitable for high-heat use and contain lime scale inhibitors to help maintain Pumptec pump heads.
  • Page 4: Before Operating The Machine

    Important:If your Ninja is fitted with a 400psi pump system, we strongly recommend the use of LIQUID detergent (NOT powdered detergent), in your solution tank. Any un-dissolved powdered detergent (or grit) will damage your pump head.
  • Page 5: Internal V2 Steammate (If Fitted)

    Only one 13 amp lead per 13 amp extension lead. Plugging both of the Ninja’s electrical leads into a double wall socket is permissible as along as each socket is 13 amp 3 Kw rated. 2. Fill solution tank with clean water to required level. The heater will not operate until the float switch is covered.
  • Page 6: Emptying Soiled / Dirty Water From The Ninja

    Ninja’s electrical leads into a double wall socket is permissible as along as each socket is 13 amp 3 Kw rated. 2. Open flow control valve one turn anticlockwise, to allow free recirculation of water back to the solution tank.
  • Page 7: Emptying After Hot Solvent Extraction Cleaning

    If in doubt as to suitability of venting hose call Ashbys for technical advice. Always vent solvent fumes outside. Open windows and / or doors for fresh air ventilation.
  • Page 8: Good Practices

    Good Practices  This equipment should be serviced every six months at Ashbys premises – call our Service Dept on 01795 436999 to book.  Always use a completely clean bucket to fill solution tank.  Do not over-apply powdered detergent in the solution tank.Powder is not recommended for piston pumps i.e.
  • Page 9: Exploded Diagram

    Exploded Diagram Page 9 of 11...
  • Page 10: Wiring Diagram For Standard Ninja With Built In Immersion Heater

    Wiring diagram for Standard Ninja with Built in Immersion Heater Page 10 of 11...
  • Page 11: Warranty Terms & Conditions

    We, Ashby’s Specialist Cleaning Equipment, (hereinafter referred to as Ashby’s), hereby warranty our NINJA machine for one year from date of purchase if purchased new or three months from date of purchase if purchased from Ashby’s as reconditioned / second-hand. If purchased new, this is subject to a Full Service (which is chargeable –...

Table of Contents