Cleaning And Storage; Problem Resolution - JOCCA 2145 Instruction Manual

English
EN

CLEANING AND STORAGE

-Product for food use.
-Before each use, as well as for the first, clean the product with soap and water.
-Before cleaning, make sure that the device is turned off and disconnected from the mains.
-If you are going to clean it after using it, make sure it is cold before starting the cleaning.
-Do not use aggressive substances for cleaning, such as abrasive substances or other washing
agents, as otherwise they could damage the surfaces.
The motor base.
It cannot be immersed in water or any other liquid and is not dishwasher safe.
Clean it with a soft, slightly damp cloth.
Accessories.
They are all dishwasher safe.
Intensive cleaning program 1, to thoroughly clean the jar and lid you must select program 1 (see
automatic programs section).
Pour in 500 ml of water and 1 teaspoon of dishwashing detergent, then add a measuring cap of
100 ml of cleaning vinegar. Wait 20 minutes before emptying and washing the container. Let dry by
turning it upside down. Empty the carafe after each use. Leave a pause time between two programs
to allow the robot to cool down.

PROBLEM RESOLUTION

Problems found
The robot does not turn on
Code E03 flashes on the
screen
Presence of liquid under
or around the robot
TURBO function does
not work
You can not put more than
speed 4
16
Causes
is the plug connected to the
outlet?
Is the back switch connected?
Does the power outlet work
properly?
Is the Stainless Steel Measuring
Jug installed correctly?
Is the lid on the jar properly?
Is the blade mounted correctly?
Is the blade gasket in perfect
condition?
Is the lid mounted correctly?
Is the cover gasket in perfect
condition?
Have you used the appliance at
speed 10?
is the jar temperature above
60°C?
is the jar temperature above
60°C?
Solutions
Check if the device is connected to the ne-
twork. Plug the device into a mains socket
Check that the rear switch is in the ON
position
Check that the electrical outlet in your
home is working properly.
Place the jug correctly see point PLACE
THE MEASURING JAR
Fit the cover correctly, see point FITTING
THE COVER
Check that the blade is correctly mounted,
see point Removing/Installing the blades
Check the blade gasket to make sure it is
not broken or torn, if it is, replace it
Check that the cover is correctly assem-
bled, see the point to fit the cover
Check the gasket of the lid to verify that it
is not torn or torn, if it is, replace it
Remember that if you use the appliance
at speed 10 filled to the 1,5 liter level and
without the measuring cap, there may be
splashes
Check temperature, wait for temperature to
drop below 60°C again
Check temperature, wait for temperature to
drop below 60°C again