Advertisement
B More about SEQUENCER recording
e Expressed in terms of notes, the total number of
notes which can be recorded
in both SE-
QUENCER tracks is about 4500. (The number of
notes may be reduced if operations such as
depressing the pedal are carried out.)
When the remaining SEQUENCER
storage
capacity becomes 20% or less, it is indicated on
the display as ?6.
When an error tone sounds and "Ful" ap-pears
on the display, the memory is full and the recording
mode stops automatically.
Playback
1. Confirm that the indicators are lit for the tracks you
wish to have played back.
SEQUENCER
STARWSTOP [RECORD] т!
de
0000
o Tracks whose indicators are not lit will not be played
back.
e The tempo setting will appear on the display.
Erasing a track
While pressing the MODE SET button, press the but-
ton for the track you wish to erase until a beep tone
sounds (about 2 or 3 seconds).
E
ios dieci:
Ü
O0
e The contents of the track are erased, and "сг"
appears on the display.
e You can erase both tracks at the same time by
pressing the two track buttons simultaneously.
e You cannot erase a track by this method when the
RECORD button is on.
The contents of the SEQUENCER
remain in the
memory for about one week after the POWER is
turned off.
14
You cannot record both tracks at the same time.
The count VOLUME and BEAT settings will be
the same as the current METRONOME settings.
(Refer to page 11.)
You can use the METRONOME while recording.
For difficult tunes, for example, you can record at
a slow speed and play back at a higher speed
without changing the pitch.
. Press the START/STOP button.
START/STOP
B
The recorded tune is played back from the
beginning.
If the METRONOME is on, playback begins with a
one-measure count.
You can adjust the playback speed with the TEMPO
buttons.
If the recording procedure was not performed
correctly, "Err" will appear on the display when you
attempt to play back the tune.
Advertisement
