Table of Contents
Advertisement
Options Summary
Bits per second EMS
Selects serial port transmission speed. The speed must be matched on the other side.
Long or noisy lines may require lower speeds.
Flow Control EMS
Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a 'stop' signal can be sent to stop the data flow. Once the
buffers are empty, a 'start' signal can be sent to re-start the flow. Hardware flow control
uses two wires to send start/stop signals.
Chapter 3 – AMI BIOS Setup
115200
None
Hardware RTS/CTS
Software Xon/Xoff
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
108
Advertisement
Table of Contents
