Advertisement
Section 2. Safety Advice
Please read this booklet thoroughly before installing and switching on the
-
appliance. The manufacturer accepts no responsibility for incorrect
installation and usage.
If this appliance is to replace an old refrigerator with a lock, as a safety
-
measure break or remove the lock and/or door before disposal.
Your old appliances contain insulation gases and refrigerant that must be
-
disposed of correctly. Please ensure that the refrigerant circuit is not
damaged before the appliance is taken away for correct disposal in line with
current legislation. If there is any doubt contact your Local Authority for
instructions.
This appliance may contain the refrigerant isobutene (R600a). This is a natural
-
gas with a high level of environmental compatibility; however, caution is required
as isobutene is a flammable gas. It is essential to ensure that refrigerant tubes
are not damaged during transportation and the installation of the appliance. In
the event that the refrigerant circuit is damaged, avoid naked flames or sources
of ignition and ventilate the room in which the appliance is situated.
Do not damage the refrigerant circuit.
-
Do not allow children to play with plastic bags – tear the bag(s) immediately
-
and ensure that they are placed in a dust-bin out of reach.
The appliance is not intended for use by persons (including children) with
-
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning the use of the appliance by a person responsible for their
safety. Children should be supervised to ensure that they do not play with
the appliance.
If using an adaptor, this must be used in accordance with the manufacturers
-
instructions and ensure that the electrical circuit is not overloaded as this
could cause overheating.
Do not twist or bend the cables, and keep them away from hot surfaces.
-
Do not plug ın or unplug this appliance with wet hands.
-
Following installation make sure that the power cable is not trapped
-
underneath the appliance.
If the power supply cord is damaged, it must be replaced by the
-
manufacturer, it's service agent or similarly qualified persons in order to
avoid a hazard.
6
Advertisement
