Advertisement
Quick Links
8 0 0 M M
Installation and aftercare instructions:
Before you start it is recommended that the mirror is secured to a suitably reinforced wall to ensure stability. Wall plugs
are only suitable for solid stone/brick walls. For plasterboard walls use specialist wall plugs (not supplied).
Wear suitable eye protection when drilling. Take care when using power tools near water -the use of a residual current
device (RCD) is recommended. Beware of hidden pipes or cables. Take care when drilling tiled surfaces as the drill might
slip. Use a piece of masking tape to prevent the drill from wandering.
MRTL063 IOWA R2
(DL-03D-S)
Features:
High density LED technology
IR Motion sensor switch
SQ Class ultra-clear flat glass surface
Copper free silver mirror with Valspar Anti-Oxidation coating
LED lifespan over 100,000 hours
Compliant with CE, EMC, LVD, IP44, RoHS
100.25MM
93.5MM
600MM
Unit 2 Bluebell Industrial Estate, Dublin 12
Tel: 01 450 4307 Email: sales@rtlarge.ie
www.rtlarge.ie
599.5MM
Advertisement
Related Manuals for R.T. LARGE MRTL063 IOWA R2
Summary of Contents for R.T. LARGE MRTL063 IOWA R2
- Page 1 MRTL063 IOWA R2 (DL-03D-S) Features: High density LED technology IR Motion sensor switch SQ Class ultra-clear flat glass surface Copper free silver mirror with Valspar Anti-Oxidation coating LED lifespan over 100,000 hours Compliant with CE, EMC, LVD, IP44, RoHS 100.25MM 599.5MM...
- Page 2 Installation Procedure IMPORTANT: ALLWAYS SWITCH OFF THE ELECTRICAL SUPPLY AT THE MAINS DURING INSTALLATION AND MAINTENANCE. 1. Before installation. Decide on a desired location for the mirror. Be mindful of hidden water pipes or electrical cables behind the wall. It is recommended that infrared sensor (if applied) is kept a minimum distance of 150mm from the adjacent wall.
- Page 3 Operating Instructions Lighting is turned on/off using the IR motion sensor switch on the lower right of the mirror, to operate, cover the sensor zone by moving your finger over it, please note there is 10~15cm distance required from the sensor to the wall in order to make it work.