Table of Contents
Advertisement
ALTERNATE FUNCTION
When the "F" key is pushed before the REV/TONE button you are
able to turn the PL Tone off or on.
Watch the screen.
If the
word "TONE"
appears,
the tone is on.
When on, pressing the keys
as directed will turn it off.
Pressing this key again will turn the tone on again.
9) TM/WR (Temporary Memorv/Write)
BASIC FUNCTION
When pressed this key will place information stored in
Temporary Memory Bank,
on to the screen.
The unit will then
operate in accordance with the information displayed.
Note that the temporary memory bank is not one of the 20 memory
channels available in Memory Banks A & B.
It is an additional
memory position that is easily programmable and is instantly
recallable by merely pressing the TM Key.
ALTERNATE FUNCTION
Pressing the "F" key before pressing this key will write into
the Temporary memory information presently on the screen.
10) Pri/Shift (Priority Monitor/Shift)
BASIC FUNCTION
When this key is used the unit will monitor the Priority Channel
stored in Memory Channel Bank A,
Channel 0,
every four seconds.
To release the priority mode press the key again.
AT.TERNATE FUNCTION
Pressing the "F" key before pressing this key performs the
alternate function "Shift".
By pressing this key several times
you can select (+)
shift,
(-)
shift, or no shift.
A (+)
shift means that the transmit frequency will be
higher than the receive frequency. A (-) shift means that the
transmit frequency will be lower than the receive frequency.
No
shift means that the transmit frequency will be the same as tne
receive frequency.
The preset width of the shift may be changed.
Refer to
"Changing The Shift Width".
is
11) Scan/H-L
BASIC FUNCTION
Pressing this key will cause the unit to scan.
If the
in the Direct Mode it will scan a band of frequencies.
Page 16,
"Programmable Band Scanning" to learn how to set the
limits of the band of frequencies to be scanned.
If the unit
in the Memory Mode it will scan Memory Banks
A ,
B ,
or
A
and "B",
depending on which memory banks are displayed on the
SC3r06Xl ■
ALTERNATE FUNCTION
When the "F" key is pressed first, this button will change the
Power Output from 35 watts High Power,
to 10 watts Low Power.
When in Low Power the word "LOW" will appear on the screen.
7
Advertisement
Table of Contents
