Download Print this page

TELUS Smart Door Lock Manual

How to remove and reposition

How to Remove and Reposition a Smart Door Lock

Description

This page shows how to remove and reposition a Smart Door Lock

Please read through the directions in its entirety before commencing.

Instructional Video Link

This Video link illustrates how to re-install a Smart Door lock

TELUS | How to install your Smart Door Lock

1. Phillips head screwdriver

2. Do not use and electric drill or an electric screwdriver

Table of Contents

Do you have a question about the Smart Door Lock and is the answer not in the manual?

Page 1 How to Remove and Reposition a Smart Door Lock Description This page shows how to remove and reposition a Smart Door Lock Please read through the directions in its entirety before commencing. Instructional Video Link This Video link illustrates how to re-install a Smart Door lock...
Page 2 Requirements Before Re-installing onto a New Door If the door does not meet all the requirements, you may have to contact a carpenter to fix or modify the door to work with the smart door lock. 1. Measurements a. Thickness of door (2” or 51mm thick) b.
Page 3 10. If this did not work, repeat steps 4 and 5 again 11. Attach the inside lock cover and secure it by putting in the two screws on the side and one on the bottom Connecting your Smart Door Lock to your Qolsys panel...
Page 4 1. Pull the cover off inside part of the door lock 2. On your panel swipe down from top middle of the panel 3. Select [Settings] 4. Select [Advanced Settings] 5. Select [Installation] 6. Select [Devices] 7. Select [Z-Wave Devices] 8.