BTI Ypsilon Installation Manual

Do not install this device unless you have read and understood
the details of this installation manual.
SAVE THESE INSTRUCTIONS – This manual contains important safety and
operating instructions
Before installing the device, read all instructions and cautionary markings on the battery pack, and
product powered by the battery.

GENERAL INFORMATION


This device is an electronic unit which is IP66 rated for installation within the battery
compartment of DC powered vehicles using flooded lead acid (FLA) or VRLA (GEL or AGM)
batteries.

Reverse polarity protected with inline fuses.

This device may be equipped with:
Red positive voltage sense wire, 1m (39") with M10 (3/8") terminal and 2A inline fuse
o
Black negative voltage sense wire, 1m (39") with M10 / 3/8" terminal
o
Temperature sensor either integrated into the black negative sense wire OR a separate
o
thermal probe on a 1m (39") cable
Red half-voltage sense wire, 1m (39") with M10 (3/8") terminal and 2A inline fuse
o
Hall effect sensor, 1m (39") with 20mm (13/16") or 35mm (1 3/8") hinged opening
o
External antenna, 1m (39") with magnetic back for 4G and GPS
o
Electrolyte level sensor with 2A fuse
o
CAN communication cable
o
 Your Company Ypsilon HuB Account Number and Password
 Bluetooth enabled smart phone/tablet with Android or iOS to load Y-Hub APP
phone settings must allow full access
o
 Multimeter to check battery voltage.
 Hand tools to fix M10 (3/8") terminals to battery posts / terminals.
 The supplied 12mm drill bit & stop collar to drill a mounting hole for the (optional) electrolyte
level sensor
 An accurate measuring tool or tape. (for electrolyte level sensor installation)
Screwdriver to install the Hall effect sensor. #1 Philips

 Sidecutters to trim the supplied tie wraps.
 Knife to trim black covering of the (optional) electrolyte level sensor .
 Tool to cut the lead electrolyte level sensor tube to length.
E-mail: info@bti-chargers.com
Ypsilon HuB
Battery & Asset Monitor
P/N 700.YHUB001 24/36/48/60V
P/N 700.YHUB002 60/72/80/96V
P/N 700.YHUB103 24/36/48/60V
INSTALLATION MANUAL

IMPORTANT SAFETY INSTRUCTIONS

REQUIRED FOR INSTALLATION

Ph: 905.636.9865 Fax: 905.636.9879
A 3/32" blade screwdriver could also work.
Website: www.bti-chargers.com
1