Page 4
Special Notices WARNING Certain components of this vehicle such as airbag WARNING modules and seat belt pretensioners may contain Failure to follow instructions highlighted by the Warning Perchlorate Material. Special handling may be Symbol can result in death or serious personal injury to required for service or vehicle end of life disposal.
Page 6
Thank you for partnering with Mullen Automotive, Inc. (Mullen). By operating a Mullen ONE electric van, you have joined a growing group of drivers who can fully appreciate the difference that a purpose-built vehicle can make. Please take time to familiarize yourself with this owner’s manual, the supplemental quick-start guide, and the vehicle itself. The time you invest will promote safety and ensure a great relationship with your Mullen ONE electric van.
1.2 Safety Notifications personal injury. Matters relating to damage of equipment or Before driving the Mullen ONE electric van, review this manual for property may be included in this category. important information on how to safely drive and operate the vehicle.
Mullen ONE Owner’s Manual 1.3 Configuration Options WARNING Options identified by “(if equipped)” indicate an optional Batteries normally produce explosive gases that can cause configuration is available for different models of this vehicle. personal injury. Therefore, do not allow flames, sparks or Please refer to your actual vehicle to determine if it is configured lighted substances to come near the battery.
Mullen ONE Owner’s Manual 1.5 Vehicle Specifications Useful technical parameters of the Mullen ONE are provided in the table on page 9. Table 1: Mullen ONE Vehicle Specifications One Seat w/Mobile Office Two Seats GVWR 4,881 lbs (2,226 kg) 5,298 lbs (2,406 kg) Max.
Mullen ONE Owner’s Manual 2.1 Before Starting the Vehicle 7. Ensure the gear selector dial is in Neutral (N). 8. Put the key in the ignition and turn the key to ON, but do not WARNING start the vehicle yet.
Mullen ONE Owner’s Manual Avoid aggressive acceleration and braking that will WARNING reduce electric vehicle operating range and increase wear Do not drive the vehicle if the EPS warning light is lit. on vehicle components. 2.3.6 Weather and Cruising Range...
3.1 Charging Information not use a charging cable The Mullen ONE electric vehicle requires a 220 volt AC (VAC) outlet Figure 1: The charging with signs of damage. on a 20-amp circuit. The charging cable has an electric vehicle port door.
Page 16
Equipment installation must be performed by a licensed and qualified electrician. Do not move the vehicle during charging. Do not use extension cords with the charging cable. Only use cables provided by Mullen Automotive. Figure 3: Charging port cover release.
FCC Statement on page 21. WARNING 3.4.2 Replacing a Lost Key Fob Never leave children or pets unattended in a vehicle. Replacement keys may be obtained by contacting Mullen. Contact Us Please see on page 4 for service information. CAUTION Never leave the keys in a vehicle that is unattended.
Mullen ONE Owner’s Manual 3.4.4 Using the Keyless Remote 2. Exit the vehicle and lift up the hood slightly. To lock the door remotely, using the key fob, press the lock button. Press the unlock button to unlock the door.
The following regulatory statement applies to all (RF) devices • Telecommunication equipped in this vehicle. Changes or modifications not expressly approved by Mullen This devices complies with Part 15 of the FCC Rules. Operation is Automotive could void your authority to operate the equipment.
Modification Statement are recorded by your vehicle only if a nontrivial crash situation Mullen has not approved any changes or modifications to this occurs; no data are recorded by the EDR under normal driving device by the user. Any changes or modifications could void the conditions and no personal data (e.g., name, gender, age, and...
Mullen ONE Owner’s Manual 5.2.3 Seat Belt Pretensioners 5. Insert the latch plate into the buckle until a Seat belt pretensioners are the click sound is heard. protective devices that pull a seat See figure 12. belt tight during a serious vehicle collision.
Mullen ONE Owner’s Manual An energy absorbing pad (1) To adjust the head restraint: is supported by two steel 1. Lift to raise the head stems (2). Each stem fits into a restraint so the top of the guide sleeve (3) in the top of restraint is even with the the seat.
NOTICE Airbags deploy during any sudden event, such as a collision or roll- Contact Mullen for questions regarding modifications for over, to instantly provide an air-filled cushion to protect the head persons with disabilities that may affect the advanced air and upper body.
It should not pull out again until it is reset by removing the Mullen builds vehicles custom designed for commercial use. latch plate from the buckle. If you are able to pull the We strongly advise against allowing children under 12 to ride shoulder belt out, the lockable retractor is not activated.
Tire Label located on the driver's door WARNING frame. Use of any tire or wheel not recommended by Mullen Rear-facing child seats should never be installed in a forward- can affect the safety and performance of your vehicle, which facing position.
Mullen ONE Owner’s Manual on a significantly under-inflated tire causes the tire to overheat FCC Information and can lead to tire failure. Underinflation also reduces efficiency FCC Statement on page 21. and tire tread life, and may affect the vehicle's handling and stopping ability.
Page 38
Mullen ONE Owner’s Manual Tire Markings pressure at which the maximum load can be carried by the tire. 4. Temperature Grade: See 5.6.5.3 Temperature on page 39. 5. US DOT TIN: This begins with the letters DOT and indicates that the tire meets all federal standards. The next two...
Page 40
The temperature grade for this tire is established for a tire that is properly inflated and not overloaded. Excessive speed, Table 3: Mullen ONE Vehicle Weight Limits by Model underinflation, or excessive loading, either separately or in combination, can cause heat buildup and possible tire failure.
Mullen ONE Owner’s Manual 5.10.1 Refrigerant Warning Label 5.10.2 Mobile Office Console Warning The air conditioning system relies on refrigerant that requires The mobile office console is not a seat. This label is positioned so it special handling equipment and techniques. Any service must be is visible when the front door on the curb side of the vehicle is performed by a qualified technician.
Mullen ONE Owner’s Manual 6.1.1 Charging Port Door ACC: When the key is turned to the ACC position, accessories such Release as wipers, radio, and the USB port will be powered on, but no power will be supplied to the drive train.
Page 48
Mullen ONE Owner’s Manual Turn Signals: Lift the left High Beams: With the low control lever upwards to beam headlamps on, push engage the right turn signals, the left control lever forward front and rear. See figure 33. until the high beam lights...
Page 52
Mullen ONE Owner’s Manual In the event of a failure, this multipurpose display will Home Screen and Odometer Display show an error code such as Err – XXX. The error code 1 Ready Indicator display (if any) will alternate with the power display. See Ready indicates the 9.2.1...
Page 54
Mullen ONE Owner’s Manual Motor Fault experiencing system distress and should be stopped as soon as it is safe to do so. Avoid driving the vehicle and have it serviced When illuminated, this indicator means the motor is not Contact Us immediately.
Page 56
Mullen ONE Owner’s Manual Electronic Stability Control (ESC) Indicator Eco-Sport When the ignition switch is turned ON, the indicator The vehicle is running in Eco-Sport mode when the light comes on for a few seconds. If the light does not go Eco-Sport mode indicator is active.
Mullen ONE Owner’s Manual 6.3.2 Date 6.3.3 Time Use the date screen to view Use the time screen to view or or set the current date. set the current time. 1. Go to the date screen 1. Go to the time screen by...
Mullen ONE Owner’s Manual 6.4.1 Emergency Flasher Switch and will need to be readjusted by a qualified technician. See Contact Us on page 4 for service information. Pressing the emergency flasher switch, see figure 46, will cause the 6.4.4 Reverse Lights exterior turn signal lights to flash as Reverse lights, or “backup lights,”...
Mullen ONE Owner’s Manual 6.5 Operator Controls 6.5.2.1 Accelerator Pedal When pushed, the 6.5.1 Horn accelerator pedal causes the Sound the horn by pressing the vehicle to move forward or in pad in the center of the steering reverse if the gear selector is wheel.
Mullen ONE Owner’s Manual 6.5.4 Parking Brake WARNING To engage the parking brake: Failure to apply the parking brake may allow the vehicle 1. Ensure the vehicle at a to roll, potentially causing property damage and complete stop. personal injury.
Mullen ONE Owner’s Manual 6.6.1 Control Panel Use this dial setting to defrost/defog the windshield 1. Temperature and side windows, while engaging lower heat at the Selector Dial same time. Turn the dial to red for Use this dial setting for defrosting/defogging the heat and to blue for air windshield and side windows.
Mullen ONE Owner’s Manual To raise a window, lift up on the corresponding side window Fore/Aft Lever switch. Lift the fore/aft lever to position the seat forward or The driver has the ability to raise or lower both side windows. The backward.
Mullen ONE Owner’s Manual 6.11 Camera Display 2. Locate the latches at the front of the mobile office console. The vehicle is equipped with 3. Release the latches, tip the mobile console up, and tip it a backup camera and camera toward the rear of the vehicle.
Mullen ONE Owner’s Manual Trigger Source: Change the channel destination for each trigger. 6.13 Tools The tool bag is stored Distance Grid: Choose the channel on which the distance grid will in the vehicle’s glove display. compartment, and contains Grid Position: Adjust the location of the grid lines on the display.
Mullen ONE Owner’s Manual 6.14 Mobile Office Console (if equipped) The mobile office console provides a workspace for a laptop or tablet. The console is intended for use while the vehicle is stationary. CAUTION Do not sit on the console. It...
Page 78
Mullen ONE Owner’s Manual 8.1.3.3 Coolant Reservoir 8.2 Vehicle Maintenance As coolant heats up, and Regular inspection and maintenance includes inspecting, expands, the excess volume is repairing and adjusting the vehicle at regular intervals. Routine directed to the coolant maintenance helps keep the vehicle in good working condition reservoir.
Page 81
For questions related to maintenance intervals, please contact Clean windows, inside and out, with standard glass cleaners to Mullen. Please bring the vehicle to a Mullen after-sales service or maintain good visibility through the glass. authorized maintenance service organization for inspection, service, and repairs.
Page 82
Puller BXJ-8 accordingly. Figure 93: Fuse box layout - Mullen ONE 8.5.1 Accessing the Fuse Box Follow these steps to replace a fuse: 1. Disconnect the cover by lifting bottom-right latch.
Page 84
7.7 Vehicle Towing and Recovery ..... 84 to crank a starter motor, Mullen ONE low speed, electric vehicles 7.8 Accident Response ....... 84 only require enough power to switch the power on.
Page 85
Mullen ONE Owner’s Manual NOTICE WARNING If the operator is unfamiliar with the jump-starting process, it The vehicle cannot be ‘push-started’. is advisable to have someone assist who has experience jump- To jump-start a vehicle with starting electric vehicles. Ask your fleet manager to have a another vehicle, follow these technician demonstrate the correct jump-starting process.
Mullen ONE Owner’s Manual 7.5 Bulb Replacement park in a safe area. Seek a parking area that is level and with firm ground or pavement. WARNING 3. Turn the vehicle OFF and engage the parking brake fully. Do not drive with burned out headlamps or taillights.
Page 89
Mullen ONE Owner’s Manual Changing the Tire 13. Locate the scissor jack and crank rod under the hood, as shown. See 6.13.1 Jack Storage on page 72 for information about locating and removing the scissor jack and crank rod. WARNING...
Page 91
Mullen ONE Owner’s Manual 19. Remove the tire, and 21. The goal is to have place it at flat on its side clean metal-to-metal to prevent unintended contact between the rolling. rim and the vehicle components. Any breach in this contact...
Page 93
Mullen ONE Owner’s Manual 24. Use the lug wrench and WARNING begin to tighten the After replacing a wheel with a spare, it is essential to wheel lug nuts, paying re-tighten the wheel lug nuts after 50 miles (80km) to ensure careful attention to the that vibration has not caused them to loosen.
Mullen ONE Owner’s Manual 7.9.1.1 Driving on Standing Water WARNING Avoid driving through standing water if possible. If necessary to Failure to comply with driving standards for special driving drive through standing water, reduce speed and drive carefully. conditions may result in serious injury or damage to the vehicle.
Page 96
Mullen ONE Owner’s Manual 9 Fault Conditions and Troubleshooting Symptom Possible Cause Correction 9.1 Vehicle Will Not Start ......95 The instrument 9.2 General Troubleshooting .
Page 98
Mullen ONE Owner’s Manual 9.3 Service Information 9.3.1 Contact Us Contact Us on page 4 for service information. Figure 96: VIN tags are located near windshield on the driver’s 9.3.2 Vehicle Identification side. Number (VIN) The VIN can be found on the driver’s side, near the lower corner of the windshield, or on the...
Page 99
Strikingly Different mullenusa.com/mullen-vehicle-center Part# AGIB-003X-AA...
Need help?
Do you have a question about the ONE 2023 and is the answer not in the manual?
Questions and answers