MN010200A01-AC
Chapter 2: WM800 Remote Speaker Microphone
2.3.8.1
Using Task Light in Dark Mode
Procedure:
Perform one of the following steps:
If you are...
Turning on the task light when in Dark
Mode.
Entering Dark Mode when the Task
Light is on.
When entering dark mode, you can observe the following sequence:
●
Power or Battery LED blinks green twice.
●
Audio or Bluetooth LED blinks blue twice and then stop blinking.
●
Task light blinks white twice and then stop blinking.
●
"Dark Mode On" tone plays (if WM800 RSM is set to Tone).
●
"Lights Off" voice prompt plays (if Language is selected).
2.3.9
Activating Voice Control
Prerequisites: Ensure that your WM800 RSM is turned on and connected to a radio supporting voice
assistance (ViQi) feature.
Procedure:
1. Press and hold the Three-Dot Programmable button.
"VC Ready" tone plays on the WM800 RSM speaker.
2. Speak voice command on the RSM for ViQi to initiate command.
3. Release the Three-Dot Programmable button.
You hear the voice control feedback based on your command.
2.3.10
Secondary Audio Accessory
When a secondary accessory is plugged into the audio jack, the audio routes through a secondary accessory.
34
Then, you...
a. Press and hold the Task Light button to turn on the
task light.
a. Press and hold the Task Light button for three sec-
onds.