Table of Contents
Advertisement
3.2 Assembly/Panel Removal
3.2.1 IR board Control Unit
1. Unplug the connector from the SSB.
Caution: be careful, as these are very fragile connectors!
2. Remove fixation screws [1] and connector [2] from the IR board control unit.
3. Remove the IR lens, IR board from the DECO_REAR_COVER.
When defective, replace the whole unit.
2
1
3.2.2 Stand removal
1. Remove the fixation screws [1] that secure the stand.
2. Take the stand bracket out from the set.
1
1
3.2.3 Rear Cover
Warning: Disconnect the mains power cord before removing the rear cover.
1. Remove all fixation screws [1] ,[2], [3], [4] and [5] that secure the Back cover assy.
2. Unplug the connector that marked by red box below from SSB, and release the cables from the clip.
3. Gently lift the rear cover from the TV. Make sure that wires and cables are not damaged while lifting the rear cover from the set.
Advertisement
Table of Contents
