Advertisement
ADJUSTMENT
If "TRANSMIT1"
is displayed now, go back to step 2
and restart from there again.
4. When
"APPROVED"
is displayed, the MASK key is
(13)
enabled and the set is turned on.
Procedure for MASK key initialization
(Resetting the MASK key enabled condition to the
factory-set condition}
1. While holding the FM and preset 6 keys, press RESET
to enter the test mode.
2. "TRANSMIT1"
is displayed and the MASK
key
request mode starts.
At this time, the display shows "* *" in place of "[]".
3. Press the MASK key cancel remote control for more
than 3 seconds.
4. When "TRANSMIT2"
is displayed, press and hold the
MASK key again for more than 3 seconds.
5. When
"APPROVED"
is displayed, the MASK key is
canceled, the demonstration mode is set, the test
mode is canceled and the set returns to the factory-
set condition.
(14) MASK key all-clear procedure
1. While holding the FM and preset 6 keys, press RESET
to enter the test mode.
2. Press and hold the AUDIO
key for more
than
1
second to enter the menu mode.
3. Press the Track UP/DOWN key to select "Mask key".
4. Press and hold the FM or AM key for more than 2
seconds so that "TRANSMIT1"
is displayed.
5. Point the MASK key cancel remote control toward the
light sensor and press for more than 3 seconds (until
the level indicator indicates the full condition).
6. When "TRANSMIT2" is displayed, press and hold the
MASK key again for more than 3 seconds.
If "TRANSMIT1"
is displayed now, go back to step 5
and restart from there again.
7. When
"APPROVED"
is displayed, the E2PROM
is
cleared entirely and the condition in "(11) MASK key
write
procedure
in production
line (when
the
E2PROM is in the initial status)" returns.
(15) Other
Automatic panel closing when the CD/MD is inserted is
disabled.
Pressing the ATT key ON/OFF opens or closes the
panel.
(The ATT operation can be activated from the remote
control unit.)
The DNPP/SNF key of the remote control unit (RC-510)
functions as the menu mode ON/OFF key.
The OPEN/CLOSE
key of the remote control unit (RC-
510) functions as the audio adjustment mode ON/OFF
key.
The
menu
feed
operations
occur
only with
the
necessary features.
The communication line for the Opel display does not
stop communication even when it is not connected.
Display such as "CODE OFF" is not displayed at the
moment power is turned on.
The dimmer control of the FL models or the contrast
control of the LCD models can be adjusted only to 0/5/
10 using the UP/DOWN keys.
11
12
Advertisement
